Dual SX-652, SX-692 Owners Manual

SX SERIES

INSTALLATION/OWNER'S MANUAL

Car Audio Speakers

SX652 

SX692

SX SERIES PREPARATION

Getting Started

Thank you for purchasing the SX Series car speakers. Although Dual has attempted
to make sure all of the information contained within this manual is accurate, please be
aware that any part of it is subject to change without notice.

Safety

This symbol is intended to alert the user to the presence of
important instructions. Failure to heed these instructions
can result in injury or unit damage.

To prevent injury and damage to the unit, please read and
follow the instructions in this manual.

If you feel unsure about installing this system yourself,
have it installed by a qualified audio technician.

Before installation, disconnect the battery negative (-)
terminal to prevent damage to the unit, fire and/or possible
injury.

Do not connect Amplifier or any audio source to
illumination inputs. Inputs are designed for 12 volt
power source only.

2

SX SERIES INSTALLATION

Installation

The following installation instructions are very basic. If you feel
unsure about personally installing this speaker system, Dual
recommends aquiring the services of a professional car audio
installation center.

Before installation, please follow these guidelines:

1. Be sure to carefully read and understand the instructions before
attempting to install this product.

2. For safety, disconnect the negative terminal from the battery prior to beginning the
installation.

3. For easier assembly: If additional wiring is required, we recommend
running all wires prior to mounting your speaker in place.

4. Use the highest quality connectors for a reliable installation and to
minimize signal or power loss.

5. Use caution before you drill or cut! Be careful not to cut or drill into gas
tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical
wiring when working on any vehicle.

6. Never run speaker wires underneath your vehicle. Running speaker wires
inside the vehicle provides the best protection from exhaust heat and
environmental elements.

7. Avoid running wires over, near, or through sharp edged surfaces. We
suggest you also use rubber grommets to protect any wires routed
through metal, especially the firewall.

3