Dual SBP10 User Manual
SBP10
INSTALLATION/OWNER'S MANUAL
SBP10 PREPARATION
CAUTION
!
Getting Started
Thank you for purchasing the Dual Electronics SBP10 Bandpass Subwoofer
System. Although Dual has attempted to ensure the information in this manual is
accurate, please be aware that any part of it is subject to change without notice.
Safety
THE FOLLOWING INSTRUCTIONS ARE DESIGNED TO ENSURE SAFETY
DURING INSTALLATION AND USE OF THE SBP10. FAILURE TO HEED THESE
INSTRUCTIONS CAN RESULT IN INJURY OR DAMAGE TO THE UNIT.
• To prevent injury and damage to the unit, please read and follow the
instructions in this manual.
• If you feel unsure about installing this system yourself, have it installed by a
qualified audio technician.
• Before installation, disconnect the battery negative (-) terminal to prevent
damage to the unit, fire and/or possible injury.
• Do not connect amplier or any audio source to illumination inputs. These
inputs are designed for 12 volt power only.
• Illuminite inputs are designed for 12 volt DC power source only. Do NOT
connect your illuminite product directly to your battery permanently, as it will
cause your battery to discharge. Please use a switched 12 volt source.
2
SBP10 INSTALLATION
Installation
The following installation instructions are very basic. If you feel unsure about
installing this speaker system yourself, Dual recommends aquiring the services
of a professional car audio installation center.
Before installation, please review the following guidelines:
1. Be sure to carefully read and understand the instructions before
attempting to install this product.
2. For safety, disconnect the battery negative terminal prior to beginning
the installation.
3. If additional wiring is required, we recommend running all wires prior to
mounting your speaker in place.
4. To ensure reliable performance and minimize signal or power loss, use the
highest quality connectors available.
5. Use caution before you drill or cut! Be careful not to cut or drill into gas
tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical
wiring when working on any vehicle.
6. Never run speaker wires underneath your vehicle. Running speaker wires
inside the vehicle provides the best protection from exhaust, heat and
environmental elements.
7. Avoid running wires over, near or through sharp-edged surfaces. We
suggest you also use rubber grommets to protect any wires routed
through metal, especially the firewall.
8. When running the speaker cable from the amplier, avoid running it near
sources of high current (i.e. wiring harnesses, battery cables).
9. When connecting the amp, the positive (+) speaker output from the bass amp
connects to the positive (+) terminal and the negative output (-) connects
to the negative (-) input terminal on the input cup located on the rear of
the subwoofer enclosure. DO NOT CONNECT AMP OR ANY AUDIO SOURCE TO
ILLUMINATION INPUTS, AS DAMAGE TO LIGHTS WILL OCCUR.
10. For the illumination connection, the positive (+) output from your 12V system
connects to the positive (+) input and the negative (ground) connects to
the negative (-) input on the input cup located on the rear of the subwoofer
enclosure. Improper 12V polarity will not cause damage to the lights, but they
will not illuminate.
3
Loading...