• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove trim ring from unit.
• Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting
sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
• Certain installations may require an installation kit and/or wiring
harness adapter (sold separately).
• Test for correct operation and slide into
mounting sleeve to secure.
• Snap trim ring into place.
MOUNTING SLEEVE
AL KEYS
HEAD UNIT
INSTALLATION
MOUNTING KITS
OR DASHBOARD
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
2
AM425BT INSTALLATION
Wiring Diagram
Antenna
Connector
10 AMP
AGC Fuse
FUSE
When replacing the
fuse, make sure new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio.
The AM425BT uses
one 10 amp ATM fuse
located beside the wiring
connector.
3
AM425BT OPERATION
Control Locations - Receiver
1
18
19
Release
1
Power / Mute
2
Volume / Select
3
Audio / Menu
4
USB Port
5
Eject
6
Auxiliary Input
7
Preset 6 / Folder Up / Thumbs Up
8
9
Preset 5 / Folder Down / Thumbs Down
3
17
4
16
2
15
14
11
10
1213
Preset 4 / Play / Pause
10
Preset 3 / Intro
11
Preset 2 / Random
12
Preset 1 / Repeat
13
Display
14
Tune / Track Up
15
Tune / Track Down
16
Band / Go Back
17
Mode
18
19
Bluetooth Talk
9
56
8
7
4
AM425BT OPERATION
Control Locations - Remote
Mode
1
Volume Up
2
Power
3
Select
4
Tune / Track Up
5
Volume Down
6
Band / Go Back
7
Preset 3 / Intro
8
Preset 2 / Random
9
15
14
12
17
16
13
1
2
3
4
5
6
7
8
9
10
11
Preset 6 / Folder Up / Thumbs Up
10
Mute
11
Audio / Menu
12
Preset 5 / Folder Down / Thumbs Down
13
Preset 4 / Play / Pause
14
15
Preset 1 / Repeat
16
Bluetooth Talk
17
Tune / Track Down
5
AM425BT OPERATION
General Operation
Power On/Off
Mode
Auxiliary Inputs
Volume
Display
Reset
Set the Clock
12/24-hour Clock
Press or any other button (except EJECT) to turn the unit
on. Press to turn the unit off.
Press MODE to select between AM/FM, CD player, auxiliary,
USB, operation of iPod®/iPhone® and Bluetooth. Modes of
operation are shown in the display.
NOTE: CD, USB and operation of iPod modes will not appear
unless a CD is inserted or USB/iPod devices are connected.
The AM425BT offers 3.5 mm auxiliary input port on the front
panel to connect an audio device, MP3 player, etc. Press
MODE to select AUX INPUT mode.
Adjust volume using volume knob (00-46).
Press DISP to select between clock and different types of
information, such as radio frequency, CD track/elapsed time
or MP3/WMA song information.
Press RESET upon initial installation or if abnormal
operation occurs. Reset button is located behind the front
panel.
With the unit on, press and hold DISP until the clock begins
to flash, then release. Press TUNE
and TUNE
tarily to save the selected time.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing
mode, the clock will display 24-hour time (22:00).
to adjust the minutes. Press DISP momen-
ll
to adjust the hours
nn
Setup Menu
6
Press and hold AUDIO/MENU for more than 3 seconds to
access the setup menu. Press AUDIO/MENU momentarily
to select between the menu functions and rotate the volume knob left/right to adjust or activate the desired function.
AM425BT OPERATION
General Operation - Setup Menu
Menu FunctionOptionsAction
Auto Station
Store
Local/Distance
Tuning
Tuner
Frequency
Spacing
iPod Control
Motion
Control
Auxiliary
Input
Beep
Confirmation
Programmable
Turn On Volume
Power on
Message
Scrolling
Option
Demonstration
Mode
Bluetooth
Auto Answer
AUTO STORE
LOCAL OFFActivates distance tuning (Tuner mode only).
LOCAL ON
FREQ USA
FREQ EURO
IPOD FULLEnables full iPod control.
IPOD BASICLimits iPod control to basic functions.
MOTION OFFDisables the motion control feature.
MOTION ONEnables the motion control feature.
AUX ONEnables the front panel 3.5mm auxiliary input.
AUX OFFDisables the front panel 3.5mm auxiliary input.
BEEP OFFDisables the confirmation beep.
BEEP ONEnables the confirmation beep.
PRO-VOL #
MSG OFFDisables power on message. (example: GOOD MORNING)
MSG ONEnables power on message to be displayed.
SCROLL 15 S
SCROLL ONCE
SCROLL ONPrograms unit to scroll continuously.
SCROLL OFFPrograms unit to show the first 10 characters on the display.
DEMO OFFDisables the demonstration mode.
DEMO ONEnables the demonstration message.
BT ONEnables Bluetooth functionality.
BT OFFDisables Bluetooth functionality.
ANSWER ON
ANSWER OFF
Press SELECT to seek and save 6 strong stations in the
current band. (Tuner mode only)
Activates local tuning for strong station reception only (Tuner mode only).
Programs the unit to USA tuner spacing.
(200kHz for FM and 10kHz for AM). (Tuner mode only)
Programs the unit to European tuner spacing.
(50kHz for FM and 9kHz for AM). (Tuner mode only)
Programs unit to always turn on at a specific volume
(default is OFF). Any volume level 1-30 can be selected.
Programs unit to scroll information once every 15 seconds
(default).
Programs unit to scroll once, then show the first 10
characters on display.
Programs unit to automatically answer every incoming
phone call after 2-3 rings.
Programs unit to require the
answer incoming phone calls.
button must be pressed to
7
AM425BT OPERATION
BASS TREBLE BALANCE FADER EQ LOUD SOURCE LEVEL
General Operation
Audio
Bass
Treble
Balance
Fader
EQ
Loudness
Source Volume Level
Press AUDIO/MENU momentarily to select between Bass,
Treble, Balance, Fader, Subwoofer and Source Volume
Level.
Press AUDIO/MENU until BASS appears then rotate volume
knob left/right to adjust ( -6 minimum / +6 maximum).
Press AUDIO/MENU until TREBLE appears then rotate
volume knob left/right to adjust ( -6 minimum / +6
maximum).
Press AUDIO/MENU until BAL appears then rotate volume
knob left/right to adjust
BAL EVEN represents equal balance
Press AUDIO/MENU until FADER appears then rotate
volume knob left/right to adjust (FADER FRONT 12 - FADER
REAR 12). FADER EVEN represents equal fader
Press EQ, then turn the volume knob to cycle through the
following equalization curves: FLAT (default), POP, JAZZ,
CLASSIC, BEAT, ROCK and USER. Any manual adjustment
to the Bass or Treble settings are automatically saved as
USER.
Press AUDIO/MENU until LOUD appears then rotate volume
knob left/right to adjust LOUD ON/OFF.
The source volume level control allows a gain adjustment
for each audio source: AM, FM, CD, AUX, operation of iPod,
Pandora and USB. Set the source volume level for each
mode, depending on the relative volume of each audio
source.
(BAL LEFT 12 - BAL RIGHT 12).
To set the source volume level, press AUDIO/MENU until
SRC LEVEL appears. After one second, the current mode
will appear on the display. Turn the volume knob to adjust
the audio level of the current source (-3 minimum/+3
maximum).
Note: Only the current mode will be available for
adjustment. To adjust another mode of operation, press
MODE until the desired mode is selected, then set the
source volume level for that mode.
8
AM425BT OPERATION
AM/FM Tuner Operation
Seek Tuning
Manual Tuning
Band
Storing and Recalling
Station Presets
Motion Control Overview
In Tuner mode
Press TUNE
to seek to the next strong station.
Press TUNE
radio frequency up or down one step at a time. Press and
hold to advance quickly.
Press BAND to select between FM1, FM2, FM3, AM1 and
AM2 bands.
Up to 18 FM stations and 12 AM stations can be stored. To
store a station, select the desired band and station. Press
and hold the desired preset button (1-6) for more than
2 seconds. When stored, the preset number will appear in
the display. The station can be recalled anytime by pressing
the corresponding preset button.
or TUNE
nn
or TUNE
nn
for more than one second
ll
momentarily to change
ll
Motion Control
Motion control allows you to use simple hand gestures
to control the radio. Easily perform most-used functions
such as play/pause, volume up/down, and track forwards/
backwards.
Swipe your hand:
- Up across the sensor to increase the volume
- Down across the sensor to decrease the volume
- Right across the sensor to seek up and tune to the next
strong station
- Left across the sensor to seek down and tune to the next
strong station
Put your hand over the sensor to mute the audio
In CD, USB
and iPod mode
Swipe your hand:
- Up across the sensor to increase the volume
- Down across the sensor to decrease the volume
- Right across the sensor to skip to the next track
- Left across the sensor to return to the beginning of the
previous track.
Put your hand over the sensor to pause/play the track.
Note: The motion control feature may not work properly
with a large USB flash drive or a USB cable inserted. A low
profile USB flash drive is recommended.
9
AM425BT OPERATION
CD Player Operation
Insert CD
Eject CD
Track Select
Fast Forward and Reverse
Pause
Intro
Repeat
Random
With the label facing up, insert a standard size CD into the
CD slot. The CD will automatically begin playback.
Press EJECT to eject the CD. The unit will change to
previous mode of operation. If the disc is not removed
within 10 seconds, the unit will reload the disc. The unit
does not have to be turned on to eject CD.
Press TRACK
track. Press TRACK
current track. Pressing TRACK
beginning of the previous track.
Press and hold TRACK
or reverse a track.
Press
Press
Press INT to enter the Intro menu, then turn the volume
knob to select one of the following options:
• OFF - Cancels the INT function.
• ALL - Plays the first 10 seconds of each track.
Press RPT to enter the Repeat menu, then turn the volume
knob to select one of the following options:
• ALL - Plays all tracks on CD.
• TRACK - Continuously repeats selected track.
Press RDM to enter the Random menu, then turn the
volume knob to select one of the following options:
• OFF - Cancels the RDM function.
• ALL- Plays all tracks in random order.
/II to temporarily stop CD playback.
l
/II again to resume playback.
l
to skip to the beginning of the next
ll
to return to the beginning of the
nn
or TRACK
ll
again skips to the
nn
nn
to fast forward
CD-R/CD-RW Compatibility
10
Some CD-Rs and CD-RWs may be incompatible with this
unit, depending on media type and recording method. In
addition, the following CDs may be incompatible with this
unit:
CDs exposed to extreme temperatures or direct sunlight
for extended periods of time, CDs recorded in which a
recording session failed or a re-recording was attempted
and, or encrypted or copy-protected CDs which do not
conform to the audio CD-DA red book recording standard.
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.