Drive Medical Design HX5 9JP User Manual

lifetime limited

warranty

Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.

This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi­dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.

In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.

steel hip-high chair

WARNING:

This Product has a maximum user weight limitation of
300 lbs.
Drive Medical assumes no responsibility for any damage
or injury caused by improper installations, assembly, or
use of this product.
If components are missing or damaged, please contact
your dealer immediately. DO NOT use substitute parts!

NOTE:

Do not use the chair until all the assembly steps have
been completed

Warranty:

- Limited lifetime on the frame and 1 year on upholstery

MAINTENANCE

Check all hardware periodically for tightness

This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.

If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.

© 2005 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

www.drivemedical.com

assembly instructions

1. Remove contents from box: 8 large frame screws
and bolts, 4 seat screws, 4 backrest screws, 2 arm
frames, a footrest frame, and a seat frame.

2. Using screws and nuts marked “A” attach footrest
to arm frame by inserting screw from the ouside
of frame. Secure using one of the nuts. Tighten
using a phillips head screwdriver and wrench. Be
sure that the front of the armrest corresponds to
the front of the footrest (Figure 1).

3. Attach seat frame to arm frame using screws and
bolts marked “A”. Tighten using a phillips head
screwdriver and wrench. (Figure1).

4. Attach second arm frame section to footrest
frame and seat frame using the same process.
(Figure 2)

5. Attach padded seat to seat frame using screws
marked “B” and the large diameter allen key.
Note: the seat is the square padded piece.
(Figure 3)

6. Attach padded backrest to frame using the
screws marked “C” and the small allen key.
(Figure 4)
Note: the backrest is the slightly tapered piece. It
should be placed on the frame so the smaller side
is at the top.

7. Make sure all screws are tightened before use.

figure 1

figure 3

A

B

C

figure 2

figure 4