lifetime limited warranty
Your Drive brand product is warranted to be free of defects in materials and workmanship for the lifetime of the original consumer purchaser.
This device was built to exacting standards and carefully inspected prior to shipment. This Lifetime Limited Warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the consumer of years of dependable service.
In the event of a defect covered by this warranty, we will, at our option, repair or replace the device.
This warranty does not cover device failure due to owner misuse or negligence, or normal wear and tear. The warranty does not extend to non-durable components, such as rubber accessories, casters, and grips, which are subject to normal wear and need periodic replacement.
If you have a question about your Drive device or this warranty, please contact an authorized Drive dealer.
electric patient lift
item #13240
© 2005 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
instructions
The Drive Deluxe Electric Patient Lift is designed to transfer a patient from one resting position to another. It is not a transport device. Use a sling that is recommended by the individual’s physician. During transfer, with patient suspended in a sling to the lift, do not roll caster base over objects such as raised carpet bindings, door frames, or any uneven surfaces that would create an imbalance of the lift. Use steering handles at all times to maneuver the lift.
installation
Follow Figure 1 (on right) & Figure 2 (on next page)
1The Electric Patient Lift is packed in one carton which contains the following components:
A. Mast with boom B. Base.
C. Base spreading adjustment handle.
D. Battery box, control box and control handset. E. “C” shaped push bars
F. 4/6 point cradle
2 Installation Procedure: (please refer to chart on pg.3)
A. Remove the screws (#16, #17) and washer (#20) from the base as indicated.
B. With the boom pointed in the same direction as the base legs, insert the mast (#2) into mast sleeve and ensure the mast is in place.
C. Install the screw (#16, #17) and washer (#20) on to the mast (#2) through mast sleeve.
D. Install the push handles (#14,#15) into the mast (#2) and ensure the screws (#19) on the push handles are screwed tightly.
3 Please refer to the following pictures: E. Unscrew the gold colored screw (#18)
F. Mount the control box (#4) on the bracket (#9) and screw back the bolts (#18) on the bottom of the bracket.
G. Place and clip the battery pack (#7) on the top of the bracket.
H. Insert the base spreading adjusting handle (#3) into the socket located behind the mast sleeve.
I. Attach the cradle (#11) to the end of the boom and make sure the bolts are screwed tightly.
J. The lift is now ready to operate.
Figure 1
Part# |
Description |
Qty |
1 |
Base Assembly |
1 |
|
|
|
2 |
Mast |
1 |
3 |
Spreading Adjustment Handle |
1 |
4 |
Linak Control Box |
1 |
5 |
Power Cord |
1 |
6 |
Linak Acuator |
1 |
7 |
Battery Pack |
1 |
8 |
Fitted Screws |
2 |
9 |
Mounting Bracket |
1 |
10 |
Hand Set |
1 |
11 |
4/6 Point Cradle |
1 |
12 |
Boom |
1 |
13 |
Fixed Screw |
2 |
14 |
“C” Shaped Push Bar - Right |
1 |
15 |
“C” Shaped Push Bar - Left |
1 |
Loading...