Drive Medical Design 11138-1 User Manual

lifetime limited

warranty

Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.

This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi­dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.

This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.

If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.

large bariatric
drop arm commode

item # 11138-1

© 2012 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

www.drivemedical.com

commode assembly

instructions and precautions

additional precautions:

1. Toilet seat must be in down position before

use. Failure to do so may result in breakage
of commode and possible injury.

Seat Clamps

FIGURE 1

MAX WEIGHT: 850 LBS

assembling commode

seat and lid:

1. Before assembling, allow toilet seat and lid to

reach room temperature if exposed to cold.
This will help prevent the seat and lid clamps
from cracking while being assembled onto
commode back frame rail.

2. Align the toilet seat clamps onto the back

frame rail. (Both clamps should sit outside
the pail brackets.) Push down on seat until
clamps snap firmly into place.

2. Do NOT install commode without first

reading and understanding this assembly
and instruction sheet. If you can not
understand these instructions, contact a
healthcare, dealer or technical professional
before attempting to install. Otherwise,
injury or damage may occur.

3. Inspect all parts for shipping damage

before assembly. If there is shipping damage

- DO NOT USE. Contact dealer/carrier for
further instructions.

4. Ensure ALL screws, nuts and/or bolts are

tightened.

5. Check the rubber tips on the leg extensions

for rips, wear or if they are are missing.
Immediately replace any or all if any of these
imperfections exist.

6. All four leg extensions with rubber tips MUST

touch the floor simultaneously at all times.

7. Users with limited physical strength should be

supervised or assisted while using commode.

8. Use the arm supports only for assistance.

DO NOT attempt to use the arms to support
full body weight.

9. Arms should be unlatched and dropped to

assist in transfer onto/off the device.

3. Slide pail in from front of commode.