Drive aluminum shower chair/commode Assembly Manual

lifetime limited

warranty

Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.

This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.

In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.

This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.

aluminum shower chair /
commode

www.drivemedical.com

If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.

© 2006 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

www.drivemedical.com

commode assembly

1. Remove contents from box. Place side frame on the
floor with the receivers facing up. Install the center
frame into the side frame by depressing the brass pin
and inserting both the front and rear pins into the side
frame. The center frame should be inserted first into
the receiver that runs parallel to the side frame (this is
also the front side of your commode). Once this is
locked into position, take the center frame and insert
it into the receiver that runs perpendicular to the side
frame. (This is the back side of your commode). Make
sure the brass pins clearly snap into position by pulling
back to insure the pins are fully locked into position.

1

2

SECOND

FIRST

3. To install the backrest, insert backrest into backrest
receptacles by depressing the brass pins on both sides
into the commodes back frame. The brass push pins
will snap into place when secure. Check by pulling
back to insure the back is secure and locked into place

3

5. Your commode comes with a bucket and lid as well as
a splash shield. The bucket is used while the
commode is used by the bedside. The splash shield is
used while the commode is used over the toilet. To
install position the bucket so two of the bucket tabs
are on the bucket rails on the back side of the
commode. Gently slide the bucket through the rails
until the bucket is properly positioned on the front of
the commode. To install the splash shield place the
commode over the toilet and place the splash shield
so two of the splash shield tabs are on the bucket rail.

5

FIRST

2. Place the second side frame on the floor with the
receivers facing up. Flip the side frame which is
attached to the center section and install the other
side of the center section into the side frame by
depressing the brass pin and inserting both the front
and rear pins into the side frame. The same procedure
should be followed by locking the front of the
commode in first and then locking the back of the
commode into place. Make sure the brass pins clearly
snap into position by pulling back to insure the pins
are fully locked into position

SECOND

4. To install the front foot bar depress the brass button
and insert the front foot bar and install into the front
receiving holes. You will need to depress the brass
button to insert the bar into the receiving tube and
make sure the brass pins clearly snap into place.

4

additional precautions

1. Do NOT install commode without first reading and
understanding this assembly and instruction sheet.
If you can not understand these instructions, contact
a healthcare, dealer or technical professional before
attempting to install. Otherwise, injury or damage
may occur.

2. Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO NOT USE.
Contact dealer/carrier for further instructions.

3. Ensure ALL screws, nuts and/or bolts are tightened.

4. All four legs MUST touch the floor simultaneously at
all times.

5. Users with limited physical strength should be
supervised or assisted while using commode.