Drive 13244 Instructions Manual
bariatric battery
powered lift
with four point cradle
item # 13244
www.drivemedical.com
www.drivemedical.com
EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
Rev.3.10.27.15
The Bariatric Electric Patient Lift is designed to allow
an attendant to ergonomically transfer a patient
from one resting position to another. It is not a transport device. Use a sling that is recommended by the
individual’s physician. During transfer, with patient
suspended in a sling to the lift, do not roll caster base
over objects such as raised carpet bindings, door
frames, or any uneven surfaces that would create an
imbalance of the lift. Use steering handles at all times
to maneuver the lift.
H. Insert the base spreading adjusting handle (#3)
into the socket located behind the mast sleeve.
I. Attach the cradle (# 10) to the end of the boom
and make sure the bolts are screwed tightly.
J. The Bariatric Electric Patient Lift is now ready to
operate.
FIGURE
PART DESCRIPTION QTY
1 Base Assembly 1
2 Mast 1
3 Spreading Adjustment Handle 1
4 Linak Control Box 1
5 Power Cord 1
6 Linak Acuator 1
7 Battery Pack 1
8 Mounting Bracket 1
9 Hand Set 1
10 4-Point Cradle 1
11 Boom 1
12 Hexagon Screw (12x20mm) 1
13 3” Twin Caster 2
14 4” Braked Caster 2
15 “U” Shaped Push Handle 1
instructions
The Electric Patient Lift is packed in one carton
which contains the following components:
A. Mast with boom including Drive Jumbo Actuator
B. Base
C. Base spreading adjustment handle.
D. Battery box, control box and control handset.
E. “U” shaped push handle
F. 4 point cradle
Installation Procedure: (please refer to figure 1)
A. Remove the screws (#12) from the base as
indicated.
B. With the boom pointed in the same direction as
the base legs, insert the mast (#2) into mast sleeve
and ensure the mast is in place.
C. Install the screw (#12) on to the mast (#2)
through mast sleeve.
D. Install the push handles (#15) into the reserved
position of the mast (#2) and ensure the screws
on the push handles are screwed on the mast
tightly.
E. Remove the black colored screw from the
mounting bracket (#8) located on the right side
of the mast (#2).
F. Mount the control box (#4) on the bracket (#8)
and screw back the bolts on the bottom of the
bracket.
G. Place and clip the battery pack (#7) on the top
of the bracket.
installation
WEIGHT CAPACITY: 600 LBS (272 KG)
Rev.3.10.27.15
Loading...