Dr ger Safety and KGaA RF001 User man

Dräger X-act 7000

Notes on Approval

Edition 01 - February 2019 - 93 00 082

Dräger Safety, 23560 Lübeck, Germany Made in Romania

II 1G

0158

10

X-act 7000

Type: MMG 00**

Part No
Serial No

: 8610800
: ARXX-XXXX

data

matrix

code

Ex ia IIC T4 Ga

BVS 18 ATEX E xxxx
IECEx BVS 18.xxxx
& TD&

FCC ID: X6O-RF001
IC: 5895F-RF001

Read manual for safety precautions.
Lire le manuel avant utilisation.

WARNING: Do not charge or replace battery in hazardous location.
WARNING: Use only type AA batteries.
AVERTISSEMENT: Ne pas charger ou remplacer la batterie dans
un emplacement dangereux.
AVERTISSEMENT: Utiliser uniquement des accumulateurs type AA.

IP 54

HVIN: RF001

Serial No.:
The X-act 7000 is marked with a serial number. The serial

number contains the year of manufacture in encrypted form.
Serial Number key: The third letter of the serial number speci-

fies the manufacturing year: M = 2019, N = 2020, P = 2021, R
= 2022, S = 2023, T = 2024, U = 2025, W = 2026, X = 2027, Y
= 2028, Z = 2029, etc. (Letters G, I, O, Q are omitted)

Example: Serial Number ARMB-0001: the third letter is M,
which means that the unit was manufactured in 2019.

i

FCC responsible party:
Draeger Inc.

7256 S. Sam Houston W. Parkway
Suite 100
Houston, Tx 77085 USA

phone: [phone]
e-mail: [e-mail]

Kanada:

This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Develop­ment Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interfe­rence that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le pré­sent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appa­reils radioexempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement.

USA:

Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.

This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa­tion.

This equipment generates, uses and can radiate radio fre­quency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfe­rence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television recepti­on, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by
one or more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and re-

ceiver.

 Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected.

This device complies with part 15 of the FCC Rules. Operation

 Consult the dealer or an experienced radio/TV techni-

cian for help.

is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, inclu­ding interference that may cause undesired operation.

EU:

f: 13.553 – 13.567 MHz (RFID)
H-Feld max. : < 0,05 A/m
E-Feld max. : < 5 V/m

DoC

93 00 082 - ED 4245.200 en Dräger Safety AG & Co. KGaA
© Dräger Safety AG & Co. KGaA Revalstraße 1 Tel [phone]
Edition 01 - February 2019 23560 Lübeck, Germany Fax [phone]
Subject to alteration www.draeger.com