D&R LT5200 Installation Manual

Description: Laptop Mount

Model: LT5200

INSTALLATION MANUAL

CONTENTS

UNPACKING
GENERAL DESCRIPTION
PART LIST
INSTALLATION

WARRANTY
PRODUCT RETURN POLICY

1

2
2
2
3

4
4

6/23/200

UNPACKING

Before beginning any installation, unpack the equipment received. After unpacking,
examine ALL components received for any damage that may have occurred while in
transit. If any damage has occurred, file a claim IMMEDIATELY with the courier stat-
ing the extent of damage. Check ALL envelopes, packing slips, shipping labels and
tags before removing or destroying them.
To ensure your satisfaction, open all cartons and report any shortages within 48

hours of receipt.

GENERAL DESCRIPTION

This Laptop Mount height is adjustable up (6 1/2” - 10”) and it has an adjustable, ball
bearing, detent swivel mount base. It has a built in, quick release sliding tray that ex­tends 6 1/4” in 5/8” increments.
The metalwork is painted with a black epoxy powder coat.

.

PARTS LIST

Item # Part # Description Qty

4 401-0043 BOLT,1/4-20 x 3/4" CARRIAGE,ZINC 4

4 422-0009 NUT,1/4-20, NYLOC, ZINC 4

4 403-0005 WASHER,1/4 FLAT S.A.E. 4

2

Right

Figure 1

FIGURE 1

INSTALLATION

Install 4 carriage bolts up through the Laptop Stand (2) and install washer and Nyloc
nut on each (loosely). See figure 1; 2a. Slide the Laptop Stand over the slots in the
floor plate with the bolt heads falling through and sliding under the floor plate. Tighten
the nuts to secure its position.

3

WARRANTY

D & R Electronics warrants its new products to be free from defects in material and work­manship, under normal use and service for a period of one year on parts replacement
and one year on labor.
This warranty applies only to original purchasers acquiring the product directly from D&R
Electronics, or its authorized dealers. Warranty will not be recognized without proof of
purchase or bill of sale.
This warranty is not transferable.
The warranty begins on the date of delivery to the first user/purchaser.
This warranty shall not apply to products which must be repaired due to normal wear and
tear, negligence, improper installation, abuse, misuse, or which have been altered or
modified at a facility other than D & R Electronics, or its authorized depot centers.
Units proved to be defective within the warranty period, based on an examination by D&R
Electronics, will be replaced or repaired at D & R Electronics’ option. This warranty does
not cover travel expenses or labor charges for removal or installation.
Lamps, flash tubes, batteries or other items considered consumables are not covered
under warranty.
This warranty is in lieu of all other express warranties. D&R Electronics makes no
warranties, expressed or implied, other than the express warranties contained herein

.

PRODUCT RETURN POLICY

In order to provide you with faster service, product returns for repair or replacement, must
have a Return Goods Authorization Number (RGA number). Please contact our com-
pany to obtain a RGA number before you return the product to D & R ELECTRONICS.
Write the RGA number clearly on the package. Be sure you use sufficient packing materi­als to avoid damage to the product being returned while in transit.
D & R ELECTRONICS assumes no responsibility or liability for expenses incurred for the
removal and/or the installation of products requiring service and/or repair.

D&R ELECTRONICS Co. LTD.

CANADA USA

8820 George Bolton Pkwy. 4500 Witmer Industrial Estates
Bolton, Ontario L7E 2Y4 Niagara Falls, NY, 14305-1386

Tel.: [phone] Toll Free 1-800-538-7338
Fax: [phone]

www.dandrelectronics.com

4