Doughpro Proluxe BC2325MV Service Manual

Operations Manual

REV 4

Model: BC2325MVE
Margartitaville Bun Caramelizer

formerly DOUGHPRO. New Name. Same Quality. Superior Service.

proluxe.com

Operation Instructions

Please read carefully before attempting to use this appliance.

Step 1. Carefully unpack and clean grill plates with mild soap then sponge clean

with cold water.

Step. 2. Place in location where it will be used allowing for clearances per the
dimensions indicated.

WARNING! Allow 2” minimum clearance between adjacent equipment and/or
wall areas.

Do not touch hot surfaces.

Step 3. Plug into proper 208V wall outlet. If other appliances are connected

to the same circuit make sure the total load does not exceed maximum
ampacity of the circuit. Electrical information is as follows:

208V/50/60Hz/1 phase/3800W/18.27 Amps

Step 4: Operation

Turn the unit on by pressing the power button located on the front panel

on the far left.

Zone 1

*

Front

Zone 2

Adjusting the temperature

1. To adjust the temp on *(Zone 1), hold down the MODE button for 5

seconds. Zone 1 temp should appear.

2. now hold the SET button and using the UP or DOWN arrows to raise
or lower desired temp.

3.

Once desired temp is set, press MODE to adjust

*(Zone 2) inner zone. Now hold SET and using the UP or DOWN

arrows to raise or lower desired temp. Once desired temp is reached,
press MODE again to return to the timer function.

Adjusting the timers

1. To set the desired timer on the far left control, use the UP or DOWN
arrows to adjust desired time. To initiate the countdown of the timer
press the SET button. To stop the countdown or reset the expired
timer press the SET button again.

2. To set the additional timers on the right side of the front panel, use
the UP or DOWN arrows to adjust and set the desired time. Press the
START and STOP button to begin the timer countdown. You may stop
the countdown at anytime by pressing the START and STOP button
again.

Cleaning removable pedestals:

1. Unit must be turned off to allow pedestals to cool.

2. Once the unit has cooled you can remove the pedestals and rinse them with a
mild detergent in warm water. NOTE…if using oil or butter on the buns you
will need to clean the pedestals with an approved aluminum cleaner.

3. Once the pedestals have been cleaned you will need to dry them.

4.Once all components and clean and dry then can be placed back on the unit.

CAUTION: ONLY REMOVE PEDESTALS BY SLIDING THEM OFF THE GRILL
SURFACE. FAILURE TO DO SO WILL CAUSE DAMAGE TO MAGNETS OVER TIME.

DO NOT SUBMERGE PEDESTALS UNDER WATER WHILE THEY ARE HOT. DOING
SO WILL CAUSE THEM TO CRACK AND VOID WARRANTY.