Dometic IBIS4 Series, IB36H401RIY, IB36H401RI Installation Manual

CLIMATE CONTROL
EN
IBIS4
IB36H401RI, IB36H401RIY
Air conditioning roof unit
Installation Manual
AU
IBIS4 Explanation of symbols
Original instructions
Please read this instruction manual carefully before installation and start-up, and store it in a safe place. If you pass on the device to another person, hand over this instruction manual along with it.
Table of contents
1 Explanation of symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
2 Safety and installation instructions . . . . . . . . . . . . . . . . . . . . . . . . 4
3 Target group for this instruction manual . . . . . . . . . . . . . . . . . . . . 5
4 Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
5 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
6 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
7 Labels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
8 Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
1 Explanation of symbols
DANGER! Safety instruction: Indicates a hazardous situation that, if not avoided, will
D ! !
result in death or serious injury.
WARNING! Safety instruction: Indicates a hazardous situation that, if not avoided, could
result in death or serious injury.
CAUTION! Safety instruction: Indicates a hazardous situation that, if not avoided, could
result in minor or moderate injury.
NOTICE!
Indicates a situation that, if not avoided, can result in property damage.
A
NOTE
Supplementary information for operating the product.
I
AU
Safety and installation instructions IBIS4
2 Safety and installation instructions
Please observe the prescribed safety instructions and stipulations from the vehicle manufacturer and service workshops.
The manufacturer accepts no liability for damage in the following cases:
Faulty assembly or connection
Damage to the product resulting from mechanical influences and incorrect connection voltage
Alterations to the product without express permission from the manufacturer
Use for purposes other than those described in the operating manual
2.1 Handling the device
WARNING!
Installation and repair of the roof air conditioner may only be carried out by
!
qualified personnel who are familiar with the risks involved and the relevant regulations. Inadequate repairs may cause serious hazards. For repair ser­vice, please contact the service centre in your country (addresses on the back page).
!
Electrical devices are not toys.
Keep electrical devices out of reach of children or infirm persons. Do not allow them to use electrical devices without supervision.
Persons whose physical, sensory or mental capabilities or whose lack of experience and knowledge prevent them from using the device safely should not use it without supervision or instruction by a responsible person.
Do not undo the upper cover of the roof air conditioner in the event of a fire. Use approved extinguishing agents instead. Do not use water to extinguish fires.
CAUTION!
The roof air conditioner must be installed securely so that it cannot fall down.
Only operate the roof air conditioner if you are certain that the housing and the cables are not damaged.
Do not use the roof air conditioner near flammable fluids or in closed rooms.
Make sure no combustible objects are stored or installed near the air outlet. A distance of at least 50 cm must be kept.
Do not reach into air outlets or insert any foreign objects in the device.
A
NOTICE!
Only use the device as intended.
The roof air conditioner is not suitable for use in agricultural or construction vehicles.
AU
IBIS4 Target group for this instruction manual
Do not make any alterations or conversions to the device.
Never drive through automatic car washes when the roof air conditioner is mounted.
If faults occur in the refrigerant circuit, the system must be checked by a spe­cialist company and repaired properly. The refrigerant must never be released into the air.
NOTE
Please ask your vehicle manufacturer if a technical inspection is required after
I
fitting an air conditioner and whether the height entered in the vehicle docu­ments needs to be altered: – IBIS4: increased height 230 mm
2.2 Handling electrical cables
WARNING!
The electrical power supply may only be connected by a qualified electrician.
!
The appliance shall be installed in accordance with national wiring regula­tions.
CAUTION!
Attach and lay the cables so that they cannot be tripped over or damaged.
!
NOTICE!
Use cable ducts to lay cables through walls with sharp edges.
A
3 Target group for this instruction manual
Do not lay loose or bent cables next to electrically conductive materials (metal).
Do not pull on the cables.
The instructions in this manual are intended for qualified personnel at workshops who are familiar with the guidelines and safety precautions to be applied.
AU
Scope of delivery IBIS4
1
2
3
4
5
6
7
8
1
4 Scope of delivery
No. in
fig. 1
1 1 Roof air conditioner
21Roof plate
3 1 Air distribution box (ADB)
4 1 ADB centre cover
5 5 Duct sections
63Cable connectors
7 4 Long fastening bolts
8 1 Remote control (with batteries)
Quantity Description
5 Accessories
Available as accessories (not included in the scope of delivery):
Description
Duct section Additional duct sections to allow fitment to thicker roof
AU
IBIS4 Intended use
2
3
ADB data label inside the ADB centre cover
6 Intended use
The IBIS4 air conditioner is designed for installation on the roof of a caravan or recreational vehicle to provide reverse cycle heating and cooling. The device is intended for vehicles with roofs that are from 20 to 100 mm thick. The device must be installed so that it is within ±10° of the horizontal plane. It is not suitable for houses and apartments.
The roof air conditioner is not suitable for installation in construction machines, agricultural machines or similar equipment. It will not work properly if exposed to strong vibrations.
The function of the roof air conditioner is guaranteed for temperatures between –2 °C and 52 °C.
NOTE
You can find additional information on roof air conditioners in the operating
I
manual, such as the technical description or the controls.
7Labels
Product data label location on rooop unit
Labels are attached to the IBIS4 roof air conditioners. These labels provide the user and fitter with information on specifications of the device.
The roof air conditioner label is located on the side of the electronics box and can be seen through the side vent. The ADB label is located inside the centre cover.
AU
Installation IBIS4
8Installation
CAUTION! Beware of injury
The roof air conditioner may only be installed by qualified personnel. The fol-
!
lowing information is intended for technicians who are familiar with the guide­lines and safety precautions to be applied.
8.1 Note on installation
Read this installation manual completely before installing the roof air conditioner.
The following tips and instructions must be observed while installing the roof air conditioner:
DANGER! Danger of electrocution
Disconnect all power supplies when working on the roof air conditioner.
D !
A
CAUTION! Beware of injury
Improper installation of the roof air conditioner can result in irreparable damage to the device and put the safety of the user at risk.
The manufacturer assumes no liability for malfunctions and for the safety of the roof air conditioner, especially for injury and/or damage to property, if the roof air conditioner is not fitted in accordance with these installation instructions.
Always wear the recommended protective clothing (e.g. protective gog­gles, gloves).
NOTICE! Beware of damage
Observe the structural engineering of the vehicle and seal of all openings made when installing the roof air conditioner.
Check whether the roof of the vehicle is able to support the weight of a per­son before climbing onto it. Ask the vehicle manufacturer about the permis­sible roof loads.
Loading...
+ 16 hidden pages