D Link CS2130A1 User Manual
Table of Contents
Product Overview ........................................................ 4
Package Contents ................................................... 4
System Requirements ............................................. 4
Hardware Overview .....................................................5
Front ..................................................................5
Rear ................................................................... 6
Side ....................................................................7
Installation ....................................................................8
Starting the Camera Installation Wizard .................. 8
Connecting Wirelessly Using WPS .......................... 9
Conguration ............................................................. 10
Using the Conguration Menu ............................... 10
Live Video ..............................................................11
Setup ..................................................................... 13
Wizard .............................................................. 13
Internet Connection Setup Wizard ...................13
Motion Detection Setup Wizard .......................16
Network Setup .................................................18
Time and Date .................................................31
Event Setup .....................................................32
Application .................................................... 33
Add Server .................................................... 34
Add Media ..................................................... 35
Add Event ..................................................... 37
Add Recording ..............................................39
SD Card ........................................................... 41
Advanced ............................................................... 42
Digital Input/Output .......................................... 42
HTTPS ............................................................. 43
Access List ....................................................... 44
Maintenance .......................................................... 45
Device Management ........................................45
Backup and Restore ........................................46
Firmware Upgrade ........................................... 47
Status ....................................................................48
Device Info .......................................................48
Logs ................................................................. 49
Help .................................................................50
Wireless Setup ................................................. 21
Dynamic DNS ..................................................23
Image Setup ....................................................24
Audio and Video ..............................................26
Preset ..............................................................28
Motion Detection ..............................................30
Appendix ....................................................................51
DI/DO Input Specications ....................................51
Technical Specications ........................................ 52
2D-Link DCS-2130 User Manual
Preface
D-Link reserves the right to revise this publication and to make changes in the contents hereof without obligation to notify any person or
organization of such revisions or changes.
Manual Revisions
Revision Date Description
1.0 June 14, 2011 DCS-2130 Revision A1 with rmware version 1.00
Trademarks
D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the United States or
other countries. All other company or product names mentioned herein are trademarks or registered trademarks of their respective
companies.
Copyright © 2011 D-Link Corporation.
All rights reserved. This publication may not be reproduced, in whole or in part, without prior expressed written permission from D-Link
Systems, Inc.
3D-Link DCS-2130 User Manual
Product OverviewProduct Overview
DCS-2130 Network Camera
CAT5 Ethernet cable
Power adapter
Camera stand
CD-ROM with User Manual and software
Quick Installation Guide
If any of the above items are missing, please contact your reseller.
Package Contents
System Requirements
Existing 10/100 Ethernet-based network or 802.11n/g wireless network
Computer with Windows 7/Vista/XP for Camera Setup Wizard
Internet Explorer, Firefox, Opera, or other web browser for web interface
(Internet Explorer recommended for full functionality)
If any of the above items are missing, please contact your reseller.
4D-Link DCS-2130 User Manual
Hardware Overview
Hardware Overview
Status LED
Indicates the camera's current status
Hardware Overview
Front
Camera Lens
Records video of the surrounding area
Microphone
Records audio from the surrounding
area
5D-Link DCS-2130 User Manual
Hardware Overview
Ethernet
Connects to your network via an Ethernet
cable
WPS Button and LED
Press this button, then press the WPS
button on your router to set up a wireless
connection automatically
Rear
Power Connector
Connects to the included DC 5 V
power adapter
I/O Connector
I/O connectors for external devices
Adjustment Ring
Tighten or loosen the adjustment
ring to adjust the camera's position
Reset
Press and hold this button for 10 seconds
to reset the camera
Base Holes
Can be used with cable ties to
attach camera to a surface
6D-Link DCS-2130 User Manual
Hardware Overview
Side
MicroSD Slot
Accepts MicroSD ash memory
cards for recording snapshots
Audio Out Port
Connects to an external speaker
(optional)
7D-Link DCS-2130 User Manual
Installation
Installation
Starting the Camera Installation Wizard
Insert the Installation CD-ROM into your computer’s optical drive to start the autorun program.
The CD-ROM will open the Camera Setup Wizard. Simply click the Start button to go through the Setup Wizard, which will guide you
through the setup process from connecting your hardware to conguring your camera.
8D-Link DCS-2130 User Manual
Installation
Connecting Wirelessly Using WPS
Alternatively, you may create a wireless connection by using the WPS Button on the
back of the camera.
To create a WPS connection:
Step 1
Press and hold the WPS button on the back of the camera for three seconds. The WPS
status LED above the button will blink.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is usually
on the front or side of your router. On some routers, you may need to log in to the web
interface and then click on an onscreen button to activate the WPS feature. If you are not
sure where the WPS button is on your router, please refer to your router’s User Manual.
The DCS-2130 will automatically create a wireless connection to your router. While
connecting, the green LED will ash and your camera will reboot.
9D-Link DCS-2130 User Manual
Conguration
Conguration
Using the Conguration Menu
After completing the Camera Setup Wizard, you are ready to use your camera. The camera’s built-in Web conguration utility is
designed to allow you to easily access and congure your DCS-2130. At the end of the wizard, click the Go To Camera button, or enter
the IP address of your camera into a web browser, such as Internet Explorer. To log in, use the user name admin and the password
you created in the Installation Wizard. If you did not create a password, the default password is blank. After entering your password,
click the OK button.
Note: If you are directly connecting your PC to the camera, or if you are using the camera on a closed network, the default IP is
192.168.0.20.
10D-Link DCS-2130 User Manual
Conguration
Live Video
This section shows your camera’s live video. You may select any of the available icons listed below to operate the camera. You may
also select your language using the drop-down menu on the left side of the screen.
You can zoom in and out on the live video image using your mouse. Right-click to zoom out or left-click to zoom in on the image.
Digital Input
Indicator
Motion Trigger
Indicator
Recording
Indicator
Video Prole 1
Video Prole 2
Video Prole 3
Full screen mode
Taking a Snapshot
Recording a Video Clip
Set a Storage Folder
This indicator will change color when a digital
input signal is detected.
This indicator will change color when a trigger
event occurs.
Note: The video motion feature for your
camera must be enabled.
When a recording is in progress, this indicator
will change color.
Listen/Stop Listening
Talk/Stop Talking
Start/Stop Digital Output
Control Pad
This control pad can be used to pan, tilt, and zoom
within the camera's predened view area, if one
has been dened.
11D-Link DCS-2130 User Manual
Conguration
Go To:
(Preset List)
SD Status:
IO Status:
PTZ Control:
ePTZ Speed:
Global View:
Language:
If any presets have been dened, selecting a preset from this list
will display it.
This option displays the status of the SD card. If no SD card has
been inserted, this screen will display the message "Card Invalid."
This option displays the status of your I/O device if a device has
been connected.
This camera uses electronic pan/tilt/zoom (ePTZ) to select and
view areas of interest in the eld of view. Please see page 26 for
information about setting the frame size and view window area.
You may select a value between 0 and 64. 0 is the slowest and 64
is the fastest.
This window indicates the total eld of view (FOV) of the camera.
The red box indicates the visible region of interest (ROI).
You may select the interface language using this menu.
Auto Pan Starts the automatic
panning function. The
ROI will pan from back
and forth within the
FOV
Stop Stops the camera
ePTZ motion
Preset Path Starts the camera's
motion along the
predened path
12D-Link DCS-2130 User Manual
Conguration
Setup
Wizard
To congure your Network Camera, click Internet Connection
Setup Wizard. Alternatively, you may click Manual Internet
Connection Setup to manually congure your Network Camera and
skip to page 22.
To quickly congure your Network Camera’s motion detection
settings, click Motion Detection Setup Wizard. If you want to
enter your settings without running the wizard, click Manual Motion
Detection Setup and skip to page 27.
Internet Connection Setup Wizard
This wizard will guide you through a step-by-step process to
congure your new D-Link Camera and connect the camera to the
internet. Click Next to continue.
Note: Select DHCP if you are unsure of which settings to choose.
Click Next to continue.
13D-Link DCS-2130 User Manual
Conguration
Select Static IP if your Internet Service Provider has provided you with
connection settings, or if you wish to set a static address within your
home network. Enter the correct conguration information and click Next
to continue.
If you are using PPPoE, select Enable PPPoE and enter your user name
and password, otherwise click Next to continue.
If you have a Dynamic DNS account and would like the camera to update
your IP address automatically, Select Enable DDNS and enter your host
information. Click Next to continue.
Enter a name for your camera and click Next to continue.
14D-Link DCS-2130 User Manual
Conguration
Congure the correct time to ensure that all events will be
triggered as scheduled. Click Next to continue.
If you have selected DHCP, you will see a summary of your
settings, including the camera's IP address. Please write down
all of this information as you will need it in order to access your
camera.
Click Apply to save your settings.
15D-Link DCS-2130 User Manual
Conguration
Motion Detection Setup Wizard
This wizard will guide you through a step-by-step process to congure your
camera's motion detection functions.
Click Next to continue.
Step 1
This step will allow you to enable or disable motion detection, specify the
detection sensitivity, and adjust the camera’s ability to detect movement.
You may specify whether the camera should capture a snapshot or a video
clip when motion is detected.
Please see the Motion Detection section on page 27 for information about
how to congure motion detection.
Step 2
This step allows you to enable motion detection based on a customized
schedule. Specify the day and hours. You may also choose to always
record motion.
16D-Link DCS-2130 User Manual
Conguration
Step 3
This step allows you to specify how you will receive event notications
from your camera. You may choose not to receive notications, or to
receive notications via e-mail or FTP.
Please enter the relevant information for your e-mail or FTP account.
Click Next to continue.
Step 4
You have completed the Motion Detection Wizard.
Please verify your settings and click Apply to save them.
Please wait a few moments while the camera saves your settings and
restarts.
17D-Link DCS-2130 User Manual
Loading...