Page 1
HDMI Over IP-PRO DSX
PRO DSX - HDMI Over IP
Network Switch Configuration
For DLINK DGS 1210-28p
Revision: 1.1
Octava Inc.-7078 Peachtree Ind. Blvd Suite 300
Norcross, Ga. 30071
Tel 770.825.0388
www.octavainc.com
All prices and specifications
are subject to change without notice.
All trademarks are the sole property of their respective companies.
Page 2
Customizable Matrix Control App ( available for iOS, and Android Devices)
System Application Diagram
Page 3
Introduction:
Scope: This guide provides a reference for configuring your network switch to work with the
Octava PRO DSX HDMI Over IP Matrix System.
This configuration guide is based on the DLINK DGS1210-28P
In this guide we will configure the network switch so some of the advanced features are
enabled:
Jumbo frame : jumbo frames are Ethernet frames with more than 1500 bytes of payload.
Multicast Video: Multicast as compared to Unicast is a more efficient method of delivering
video to multiple clients. Multicasting requires only 1 “channel/group” to be transmitted
regardless of number of clients that will subscribe to the “channel/group”. Unicast would
require 1 stream for each client , thus would increase the bandwidth requirement by N(
number of clients).
IGMP ( internet group management protocol): IGMP Querying/Snooping, optimizes
network loading by ensuring that Multicast traffic is only forwarded to ports that are
members of that Multicast group.
Page 4
1. Connect a LAN cable directly from you PC to the network switch.
2. Set your computer network settings to :
IP Address: 10.0.0.2
Subnet : 255.0.0.0
Gateway: 10.0.0.1
3. Open a browser and enter the IP address of the DLINK: 10.90.90.90
Page 5
4. Select Standard mode and Exit
5. Select VLAN
Page 6
6. Select 802.1Q VLAN
7. Select all ports and set as Untagged
8 . Select L2 Functions. Set JUMBO Frame = Enable
Page 7
9 . Go to Multicast and set as follows:
Set IGMP Snooping = Enable
Host Time Out = 260
Robustness Variable = 2
Query Interval= 125
Router Timeout = 125
Last Member Query Interval = 1
Max Response Time = 10
Page 8
10. Goto / Multicast / IGMP Snooping
State = Enabled
Querier State = Enabled
Fast Leave = Enabled
11. Set port 28 as Static Router Port . Leave other ports unselected
Page 9
12. Goto Multicast / Multicast Filtering Mode
Set Filtering mode = Forward Unregistered Groups
13. Save
14. Reboot Device
Loading...