Dinex TSBH2DV User Manual

Model Number
TSBH2DV
Application
The two tube convection air heat­ing unit is an efficient and eco­nomical means of heating all stain­steel wax bases.
Exterior shall be 304, No. 20 finish stainless steel. Welds shall be ground. Frame shall be 22 gauge. Each tube shall have a separated heavy duty all stainless steel center hinged lid. The sides, back an front panel shall be 20 gauge stainless steel. Four 5” (13cm) swivel caters, two with wheel locks shall be provided. A non-marking, polyethylene, heavy duty wrap around bumper is standard.
Wax Base Dispensing System
The dispensing system for the units shall be a tube type self­leveling dispenser with 20 heavy duty spri n g s. See operating manu a l for calibration instructions. The TSBH2DV will heat wax bases from room temperature to approxi­mately 250° (118°C) in 2 hours (initial “heat up” of the day). Reheat, after initial meal of the day, will take approximately 1 hour 30 minutes.
Two Tube Convection Base Heater Horizontal forced air convection heat system circulates thermostat­ically controlled heat air evenly throughout the well-insulated cabinet. The two tube unit is 3400
watts at 240 volts, 14.6 amps. and 2550 watts at 208 volts, 12.3 amps.
Electrical and Controls
Electrical controls consist of “On/Off” switch, “On” light and an overtemp thermostat. Temperatures are adjustable with a variable thermostatic control inside. The heater shall be provided with the electrical tension (voltage) by an “AWG 14” connection cable, 208/240 volts. The units requires a dedicated 20 amp, single phase receptacle.NEMA plug 6-20P. Cord Length 6 ft.
Warranty
One year parts and labor.
ITEM #
BASE HEATER
International, lnc.
Building 2, Suite 106 628 Hebron Avenue Glastonbury, CT 06033-5006 (800) 523-9752 Fax: (860) 652-3135 http://www.dinex.com
TMP-008-REV 01/05
JOB
MODEL: TSBH2DV
Plug Configuration for Dinex Base Heater
2 Pole, 3 Wire
208/240 volts, 20 amps
Plug: NEMA 6-20P
International, lnc.
Building 2, Suite 106 628 Hebron Avenue Glastonbury, CT 06033-5006 (800) 523-9752 Fax: (860) 652-3135 http://www.dinex.com
TMP-008-REV 01/05
BASE HEATER
Please confirm that you have the most current specification sheet by visiting www.dinex.com.
Dinex®reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
Printed in USA
Item and Dimensions
MODEL
NUMBER
TSBH2DV
26”
(66cm)
38.875” (99cm)
44.625”
(113cm)
323 lbs.
(146.6kg)
29.0
LENGTH DEPTH
HEIGHT
SHIP
WEIGHT
SHIP
CUBE
Length
Depth
Top View
Loading...