Dimplex DF2608 User Manual

Quality checked by:

PRACTICAL USER’S GUIDE

FOR THE DIMPLEX

ELECTRIC FIREPLACE

MODEL NUMBER:

DF2608

Valued Customer,

We are pleased that you have chosen to purchase an electric fireplace by Dimplex North America Ltd. Over the years, valuable memories will occur around the warmth and comfort of your hearth. Thank you for allowing our product to

be the backdrop for those special moments.

7208680100R01

CONTENTS

PAGE Important Instructions PAGE Fireplace Installation PAGE Operation PAGE Maintenance PAGE Warranty

Quick Reference Guide for the Dimplex Electric Fireplace

1. Prior to the first use of the fireplace verify the following:

• Are the circuit breakers for the socket the

unit uses on?

• Are the light bulbs in your fireplace

loose? (to check, follow the instructions for replacing the light bulbs under the maintenance section of this manual)

2. The heater on your fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again.

3. The information regarding the model of your fireplace can be found on the rating plate. See Page 2 for location.

4. If you have any technical questions regarding the operation or service of your fireplace have your Model and Serial Number ready, and contact Dimplex North America technical support at 1-888-DIMPLEX (1-888-346-7539) before returning the product to the point of purchase.

IMPORTANT INSTRUCTIONS

Please Retain This User’s Guide for Future Reference

1. Read all instructions before using the electric fireplace.

2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.

3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the unit is left operating and unattended.

4. Young children should be supervised to ensure that they do not play with the appliance.

5.The appliance is not intended for use by young children or infirmed persons without supervision.

6. The appliance must be positioned so that the plug is accessible.

7. Always unplug the electric fireplace when not in use.

8. If the supply cord is damaged, it must be replaced by the manufacturer, or it s service agent, or a qualified person in order to avoid a hazard.

9. Do not operate any unit with a damaged cord or plug, or if the heater has malfunctioned, or if the electric fireplace has been dropped or damaged in any manner. Cont act Dimplex Technical Service 1-888-346-7539.

10. Do not use outdoors.

11. Never locate fireplace where it may fall into a bathtub or other water container.

12. Do not install the fireplace directly on carpet or a similar surface which may restrict air circulation beneath the unit.

13. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over .

14. Do not locate the heater immediately below a fixed socket-outlet.

15. To disconnect the fireplace, turn the controls off, then remove the plug from the outlet.

16. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage to the heater.

17. Although this unit is of zero clearance design, to prevent a possible fire, do not block air intake or exhaust in any

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

NO USER

SERVICEABLE PARTS INSIDE

manner. Do not use on soft surfaces, like a bed, where openings may become blocked.

18. All electrical heaters have hot and arching or sp arking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored or where the unit will be exposed to flammable vapors.

19. Do not modify the electric fireplace. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.

20. Avoid the use of an extension cord. Extension cords may overheat and cause a risk of fire. If you must use an extension cord, the cord shall be No. 16 AWG minimum size and rated not less then 1875 watts.

21. Do not burn wood or other materials in the electric fireplace.

22. Do not strike the fireplace glass.

23. Always use a certified electrician should new circuits or outlets be required.

24. Always use properly grounded, fused and polarized outlets.

25. Disconnect all power supply before performing any cleaning, maintenance or relocation of the unit.

26. When transporting or storing the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage.

SAVE THESE INSTRUCTIONS

NOTE: Procedures and techniques that are considered

important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury , illness or death.

Warning Label

Important Instructions

If you have any questions regarding our products please have the product model number and serial numbers available upon calling Dimplex customer service or technical support. To locate the model and serial number labels see below . Record the model number, serial number on the front cover of this

manual for future reference.

Serial Number

Model Number

Firebox

Serial Number

Carton

WARNING

Ensure the power cord is not installed so that it is pinched or against any sharp edges and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons. Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.

+ 13 hidden pages