Dakota
Kansas
Copenhagen
UK
EN : This product is only suitable for well insulated rooms or occasional use. DE : Dieses Produkt ist nur für gut isolierte Bereiche oder gelegentliche Verwendung geeignet. FR : Ce produit convient uniquement à des endroits bien isolés ou pour un usage occasionnel. IT : Questo prodotto è
adatto solo per spazi ben isolati o per uso occasionale. ES : Este producto sólo es adecuado para espacios bien aislados o un uso ocasional. NL :
Dit product is uitsluitend geschikt voor goed geïsoleerde ruimten of voor sporadisch gebruik. PL : Produkt ten jest odpowiedni wyłącznie do dobrze
odizolowanych miejsc lub do okazjonalnego użytku. NO : Dette produktet egner seg kun for godt isolerte rom eller sporadisk bruk. RO : Acest
produs este adecvat exclusiv spaţiilor bine ventilate sau utilizării ocazionale. CZ : Tento výrobek je vhodný pouze do dobře izolovaných prostor
nebo k příležitostnému použití. DK : Dette produkt er kun egnet til velisolerede rum eller lejlighedsvis brug. PT : Este produto somente é ade-
quado para espaços bem isolados ou uso ocasional. SE : Denna produkt är endast avsedd för välisolerade utrymmen eller tillfällig användning.
FI : Tämä tuote soveltuu ainoastaan hyvin eristettyihin tiloihin tai satunnaiseen käyttöön. SK : Tento výrobok je vhodný len pre dobre izolované
priestory alebo na občasné použitie. SI : Ta izdelek je primeren le za dobro izolirane prostore ali za občasno uporabo. HR : Ovaj proizvod je
pogodan samo za dobro izolirane prostore ili povremenu upotrebu. HU : Ez a termék csak jól szigetelt terekhez vagy eseti használatra alkalmas.
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2 and EN60555-3. These cover the essential requirements of EEC Directives 2006/95/EC and 2006/108/EC
Inver
08/51197/0 Issue 4
OCN
1
C
B
A
310
547
463
615
160
2
3
Dakota / Kansas / Inver / Copenhagen
Model: DKT20 / KNS20 / INV20 / COP20
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
UK
Important Safety Advice
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of re, electrical shock and
injury to persons, including the following:
If the appliance is damaged, check with the
supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of
a bath, shower or swimming pool.
Do not locate the appliance immediately
below a xed socket outlet or connection
box.
The appliance carries the Warning symbol
DO NOT COVER, indicating that it must not
be covered.
This appliance can be used by children
aged form 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by Children
without supervision.
Children of less than 3 years should be
kept away unless continuously supervised.
Children aged from 3 years and less than 8
years shall only switch on/off the appliance
provided that it has been placed or installed
in its intended normal operating position
and they have been given supervision or
instruction concerning use of the appliance
in a safe way and understanding the hazards
involved. Children aged from 3 years and
less than 8 years shall not plug in, regulate
and clean the appliance or perform user
maintenance.
Do not use this appliance in series with a
thermal control, a program controller, a timer
or any other device that switches on the heat
automatically, since a re risk exists when
the appliance is accidentally covered or
displaced.
Ensure that furniture, curtains or other
combustible material are positioned no
closer than 1 metre from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for
long periods.
Although this appliance complies with safety
standards, we do not recommend its use
on deep pile carpets or on long hair type of
rugs.
The appliance must be positioned so that the
plug is accessible.
If the supply cord is damaged it must be
replaced by the manufacturer or service
agent or a similarly qualied person in order
to avoid a hazard.
Keep the supply cord away from the front of
the appliance.
Warning: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through
an external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.
CAUTION - Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
The heater carries the Warning symbol,
indicating that it must not be covered.
This instruction can be found at
WWW.DIMPLEX.CO.UK
Technical Information
Model No: DKT20, DKT20BL, KNS20,KNS20BL, INV20, COP20
Heat Output 230V 240V
Nominal Heat Output
Minimum Heat Output
Maximum Continous Heat Output
Auxiliary Electricity Consumption
In Standby mode el SB0.02 - 0.02 W
With mechanic thermostat room temperature control.
General
Unpack the heater carefully and retain the packaging for possible
future use, in the event of moving or returning the re to your supplier.
Loose coals/pebbles are packed separately within the carton. When
the heater is assembled the coals/pebbles are placed on top of the
fuel bed
The re incorporates a ame effect, which can be used with or
without heating, so that the comforting effect may be enjoyed at any
time of the year. Using the ame effect on its own only requires little
electricity.
Before connecting the heater check that the supply voltage is the same
as that stated on the heater.
Please note: Used in an environment where background noise is very
low, it may be possible to hear a sound which is related to the operation
of the ame effect. This is normal and should not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage
marked on the heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating
instructions.
In the event of replacing the fuse in the plug supplied, a 13 amp fuse
approved by ASTA to BS1362 must be used.
P
P
1.7 - 1.9 kW
Nom
P
0.9 - 1.0 kW
min
1.7 - 1.9 kW
max,c
Dakota / Kansas / Inver / Copenhagen
Model: DKT20 / KNS20 / INV20 / COP20
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
UK
Installation - see Fig. 1 & 3.
Your electric re is designed to be used in a replace opening or placed
against a wall anywhere in the room.
When installing this appliance in an existing replace opening, we
recommend that an open chimney or ue is blocked off. We recommend
that non-ammable materials are used to block off the chimney ue. This
procedure is important for the efcient operation of the heating unit and
will also reduce heat loss up the chimney.
At the rear of the re, two adjustable feet are provided for levelling the
re where the re is being installed on an uneven surface. You can
adjust the foot by removing the two screws and retting the foot in the
required position.
The re is supplied with screws and rawl plugs to provide extra stability
to prevent it from accidentally being knocked over. The rawl plug supplied
is suitable for use in block walls (other wall types may need alternative
rawl plugs).
To place the appliance ush to a wall please follow these instructions:
Drill holes using a 6mm drill as illustrated in Fig.1. Insert plugs and screws.
The plug supplied is suitable for use in block walls (special fasteners
are required on stud walls). Do not fully tighten screws, leave the head
of the screw at least 10mm away from the surface. Place the keyhole
slots on the re over the screws and lower into position.
To gain access to the xing holes in the base, remove the fret and fuel
effect from the re. Remove the fret by lifting it up and then pulling it out
from the re, remove the 3 screws holding the fuel bed in place and slide
it away from the re.(See Fig. 3, shown Kansas Fret). Using the screws
provide screw the re in place as shown in Fig. 1. Carefully ret the fret
and fuel effect in reverse of the removal procedure as described above.
The other models fret removes in the same manner as the Kansas fret.
Manual Controls - see Fig. 2
Three switches provide a choice of heat setting. Each switch is activated
when the bottom half of the switch is pushed in.
Switch 1 Controls the electricity supply to the heater.
Note: This switch must be in the ON position for the heater
to operate with or without heat.
Switch 2 Provides 950 W heat output.
Switch 3 Provides 1900 W output when used in conjunction with switch2
Thermostat
In order to maintain a certain room temperature, set the thermostat
knob to ‘max.’. Operate the appliance at full power until the required
room temperature is reached. Turn back the thermostat knob until the
appliance switches off. This temperature will be kept almost constant by
the thermostat switching on and off automatically.Please note that the
appliance will only operate when the thermostat setting is higher then
the room temperature.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This re is tted with LED (Light Emitting Diode) lamps in place of
conventional bulbs . These generate the same light levels as conventional
bulbs, but use a fraction of the energy consumed. These LED lamps
are maintenance – free and should not require replacing during the life
of the product.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the soft brush attachment of
a vacuum cleaner should occasionally be used to clean the outlet grille
of the fan heater.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Your product is guaranteed for one year from the date of purchase.
Within this period, we undertake to repair or exchange this product free
of charge (excluding lamps & subject to availability) provided it has been
installed and operated in accordance with these instructions.
Your rights under this guarantee are additional to your statutory rights,
which in turn are not affected by this guarantee.
Should you require after sales information or assistance with this product
please go to www.dimplex.co.uk where you will nd our self help guide
by clicking on “After Sales” or ring our helpdesk on 0844 879 3588 (UK)
or 01 842 4833 (R.O.I.) .
Spare parts are also available on the website
www.dimplex.co.uk
Please retain your receipt as proof of purchase.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to prevent damage
due to overheating. This can happen if the heat outlet was restricted
in any way. The heater will switch on once the obstruction has been
removed and the heater has cooled. If the cut-out continues to operate
intermittently, the heater should be switched off and a service agent
contacted.
Dimplex
Millbrook House
GrangeDrive
HedgeEnd
Southampton
Hampshire.SO30 2DF
[c] GDC Group Ltd,
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex.
A division of GDC Group Ltd,
TEL: 0844 879 3588
FAX: 0844 879 3583
WEBSITE: www.dimplex.co.uk
Republic of Ireland Tel.01 8424833
Loading...