|
|
|
(AUS/NZ) |
Installation and Operating Instructions |
|||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ritz Stove |
Model: RIT20 |
|
|
|
|
|
|
08/19279/1 Issue 1 |
||||
|
Club Stove |
Model: CLB20 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||
|
510 |
340 |
510 |
|
|
340 |
|
|
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
597 |
597 |
Ritz Stove |
Club Stove |
Fig. 1 |
|
|
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice:
When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following :
•If the appliance is damaged, check immediately with the supplier before installation and operation.
•Do not use this heater in the immediate surroundings of a bath, shower or swimming pool.
•Do not use outdoors.
•This heater must not be located immediately below a fixed socket outlet or connection box.
•Do not cover or obstruct in any way the heat outlet grille located at the bottom of the heater. Overheating will result if the heater is accidentally covered.
•Ensure that furniture, curtains or other combustible materials are positioned no closer than 1 metre from the heater.
•In the event of a fault unplug the heater.
•Unplug the heater when not required for long periods.
•Keep supply cord away from the front of the heater.
•Although this heater complies with safety standards, we do not recommend its use on deep pile carpets or on long hair type of rugs.
•The appliance is not intended for use by young children or infirm persons without supervision.
•Young children or infirm persons should be supervised to ensure that they do not play with the appliance.
•The appliance must be positioned so that the plug is accessible.
•If the supply cord is damaged it must be replaced by the manufacturer or service agent or similarly qualified person in order to avoid a hazard.
General
Unpack the heater carefully and retain the packaging for possible future use, in the event of moving or returning the fire to your supplier.
This model is designed to be free standing and is normally positioned against a wall.
A choice of 1kW or 2kW heat output is provided by the fan heater, which is located at the bottom of the unit.
Before connecting the heater check that the supply voltage is the same as that stated on the heater.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is related to the operation of the flame effect. This is normal and should not be a cause for concern.
Electrical
WARNING: THIS APPLIANCE MUST BE EARTHED.
This fire is suitable for operation on an AC~ electricity supply having the same voltage as that shown on its rating label.
Before switching on, please read the safety warnings and operating instructions.
Loading...