Dimplex CNR15-AU User Manual

CONNER

CONCRETE

CNR15-AU

8/54203/0 Issue 1

The product complies with the European Safety Standards and the European Standard Electromagnetic Compatibility (EMC). These
cover the essential requirements of EEC Directives.

1

1

min max

OFF

ON

econ

2

3

II

4

2

I

3

5

CONNER CONCRETE

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice

When using elec

trical appliances, basic

precautions should be followed to reduce

the risk of fire, electric shock, and injury to

persons, including the following:
If the appliance is damaged, check

immediately with the supplier before

installation and operation.
Do not use this appliance in the immediate

surroundings of a bath, shower or swimming
pool.

Do not use outdoors.
This appliance must not be located

immediately above or below a fixed socket
outlet or connection box.

WARNING : The appliance carries

the Warning Symbol indicating that
it must not be covered or has a
Do not cover label. Do not cover
or obstruct in any way the heat outlet

grille located underneath the appliance

Overheating will result if the appliance is
accidentally covered. Do not place material

or garments on the appliance, or obstruct
the air circulation around the appliance, for

instance by curtains or furniture, as this could
cause overheating and a fire risk.

In the event of a fault unplug the heater.

Unplug the appliance when not required

for long periods. The supply cord must
be placed on the right hand side of the
heater away from the heat outlet
underneath the appliance.

This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or

to avoid a hazard.
CAUTION: In order to avoid a hazard due to

inadvertent resetting of the thermal cut-out,

this appliance must not be supplied through

an external switching device, such as a timer,
or connected to a circuit that is regularly
switched on and off by the utility.

CAUTION - Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.

General

Unpack the heater carefully and retain the packaging for possible
future use, in the event of moving or returning the re to your

supplier.

The re incorporates a ame effect, which can be used with or
without heating, so that the comforting effect may be enjoyed
at any time of the year. Using the ame effect on its own only
requires little electricity.

Before connecting the heater check that the supply voltage is

the same as that stated on the heater.

Please note: Used in an environment where background
noise is very low, it may be possible to hear a sound which

is related to the operation of the ame effect. This is normal
and should not be a cause for concern.

Electrical Connection
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the

voltage marked on the heater must correspond to the supply

voltage.

Before switching on, please read the safety warnings and

operating instructions.

Controls - see Fig. 2

Three switches provide a choice of heat settings. The appliance
is in standby mode when the mains lead is plugged in. This is
indicated by the red neon behind the ame effect screen. The

two selector switches are in the ON position when the side with
the markings on (i.e. I, or II) are pushed in.

instruction concerning use of the

appliance by a person responsible for their
safety.

Push button switch 1 Controls the electricity supply to

Children shall not play with the appliance.

Cleaning and user maintenance shall not
be made by Children.

If both selector switches 2 and 3 are in the OFF position, the

product works on ame effect only.

Children should be kept away unless
continuously supervised. Children shall not

turn on/off the appliance. Children shall

Selector switch 2 (I) Provides 750W heat output
Selector switch 3 (II) Provides 1500W output with switch

not plug in, regulate and clean the
appliance or perform user maintenance.

Thermostat (T) - see Fig. 3

The appliance must be positioned so that
the plug is accessible.

Although this appliance complies with safety

standards, we do not recommend its use on

deep pile carpets or on long hair type of rugs.
If the supply cord is damaged it must be

replaced by the manufacturer or service

In order to maintain a certain room temperature, set the controller

to ‘max.’. Operate the appliance at full power until the required

room temperature is reached. Set back the thermostatic controller
until the appliance switches off with an audible “click”. This

temperature will be kept almost constant by the thermostatic
control switching on and off automatically.Please note that the
appliance can only be switched on when the thermostat setting

is higher then the room temperature.

agent or similarly qualified person in order

the heater and ame effect.

2 also pressed.

Remote control - see Fig. 4

The maximum range of use is ~ 5metres.

Warning: It takes time for the receiver to respond to the

transmitter.
Do not press the buttons more than once within two seconds

for correct operation.

Battery Information - see Fig. 4

1. To activate the remote control remove the battery isolation
strip, which is used to ensure your remote control reaches you
fully charged.

2. To replace the remote control battery, turn over the remote

control, and follow the diagram embossed on the remote control

3. Only use CR2025 or CR2032 size of batteries.

automatically in the event of a fault! Switch off the appliance or

disconnect the mains plug from the socket.

Remove any obstructions which may have caused the
overheating. After a short cooling down phase, the appliance
is ready for use again! If the fault should occur again, see your
local dealer!

WARNING: In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on and off by
the utility.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.

WARNING - KEEP BATTERIES OUT OF REACH
OF CHILDREN

1. Swallowing may lead to serious injury in as little as 2 hours

or death, due to the chemical burns and potential perforation of
the oesophagus.

2. If you suspect your child has swallowed or inserted a button
battery immediately call the 24-hour Poisons Inforation Centre
on 13 11 26 (in Australia) or 0800 764 766 (in New Zealand) for
fast, expert advice.

3. Examine devices and make sure the battery compartment
is correctly secured, e.g. that the screw or other mechanical

fastener is tightened. Do not use if the compartment is not secure.

4. Dispose of used button batteries immediately and safely. at

batteries can still be dangerous.

Tipping Restraint - see Fig. 1

WARNING: FALLING OR TIPPING APPLIANCES CAN
CAUSE INJURY OR DEATH OF YOUNG CHILDREN, PLEASE
ENSURE CHILDREN DO NOT CLIMB, HANG OR STAND ON
THIS PRODUCT.

WARNING: THE APPLIANCE IS PROVIDED WITH A TIPPING
RESTRAINT, THIS RESTRAINT IS NOT A SUBSTITUTE FOR
PROPER ADULT SUPERVISION. THIS RESTRAINT MAY PROVIDE
PROTECTION AGAINST TIPPING FURNITURE. DO NOT ALLOW
CHILDREN TO CLIMB ON FURNITURE. FAILURE TO DETACH
THIS RESTRAINT BEFORE MOVING FURNITURE MAY RESULT IN
INJURY AND DAMAGE.

This product is provided with a ‘Tipping Restraint Kit’ as
shown in Fig 1, to prevent the product accidentally tipping
over. Fitting Instructions are supplied with this kit please
follow these instructions carefully.

Thermal Safety Cut-out

The built-in overheat cut-out switches off the appliance

Light Emitting Diode

This re is tted with LED (Light Emitting Diode) lamps. These
LED lamps are maintenance-free and should not require

replacing during the life of the product.

Cleaning

WARNING – ALWAYS DISCONNECT FROM THE POWER

SUPPLY BEFORE CLEANING THE HEATER.

For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully

with a soft cloth.

DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the soft brush

attachment of a vacuum cleaner should occasionally be used

to clean the outlet grille of the fan heater.

It is possible to clean the inner glass and logset by removing
the outer glass panel. To remove the outer glass, remove the

4 screws holding the grille in position, (see Fig.5), remove the
grille and lift clear the outer glass.

Ret the outer glass in reverse of above.

WARNING: do not operate the product without the grille and outer

glass in position as this may effect the operation of the heater.

Recycling

At the end of the electrical products useful life it
should not be disposed of with household waste.

Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.

After Sales Service

Should you require after sales service or should you need to
purchase any spares, please contact the retailer from whom
the appliance was purchased or contact the service number
relevant to your country on the warranty card.
Please do not return a faulty product to us in the rst instance
as this may result in loss or damage and delay in providing
you with a satisfactory service. Please retain your receipt as

proof of purchase.

Glen Dimplex Australia Pty Ltd.
1340 Ferntree Gully Road,
Scoresby,
VIC 3179,

Australia

www.dimplex.com.au
[e-mail]

Ph: 1300 556 816

Fax: [phone]

Glen Dimplex Australasia Ltd.

35 Harris Road,
East Tamaki,
Auckland

New Zealand

www.dimplex.co.nz
[e-mail]

Ph: 09 274 8265
Fax: [phone]