DiMarzio Pre B-1 User Manual

Page 1 of 1D i M a r z i o . c o m
DiMarzio Pre-B-1
Important: Read all of the following instructions before proceeding. If any questions or problems arise, you may refer them directly to us.
Please Note:
The Pre-B-1 was designed to function properly without a metal plate attached to the underside. We do not recommend installing such a plate on this pickup because it may cause some treble loss and microphonic feedback. However, the plate was responsible for grounding the bridge assembly, which is still important to maintain. To accomplish this grounding, run a wire from the common ground on the volume pot thru to the treble pickup hole and strip 1-2 inches of insulation off the wire. Place the bare end between the bridge and guitar body so it is securely held down when the bridge is screwed back on the guitar.
Fender, Stratocaster, Strat, Telecaster, Tele, Precision Bass, P-Bass, Jazz Bass and J-Bass are registered trademarks of Fender Musical Instrument Corp., with which DiMarzio, Inc. is not affiliated. Les Paul and Les Paul Junior are registered trademarks of Gibson Guitar Corp., with which DiMarzio, Inc. is not affiliated. Parker Fly is a registered trademark of Parker Guitars, with which DiMarzio, Inc. is not affiliated.
*****
DiMARZIO, INC.
1388 Richmond Terrace
Post Office Box 100387
Toll Free Order Desk (outside NYC): 800-221-6468
Customer Service (and NYC orders): 718-981-9286
Technical Assistance (12:00 PM - 5:00 PM ET): 718-816-8112
Fax: 718-720-5296
5/6/2004http://www.dimarzio.com/install/pre_b_1.html
Loading...