Gigabit Ethernet
PCI Express network card
User Manual
(DN-1013-2)
All brand names and trademarks are properties of their
respective owners.
Features
Designed to meet PCI Express Base Specification Revision
1.0a
Single-lane (or x1) PCI Express throughput supports rates
of 2.5Gbps
Compliant with 10/100/1000 IEEE 802.3 specification
10/100/1000M data rate auto-negotiation
LEDs indicate the status of data transmission
Automatic MDI/MDIX crossover at all speed
Support Wake On Lan(WOL) power management (optional)
Feature full duplex mode that doubles the network
connection speed
Support Windows® 2000, XP/2003/Vista/7 (32/64 bit)
System Requirements
Windows® 2000, XP/2003/Vista/7 (32/64 bit)
PCI Express-enabled system with an available PCI Express
slot
Page 2
Package Contents
1 x PCIe Gigabit Ethernet Card
1 x User Manual
1 x Driver CD
Note: Contents may vary depending on country/market.
Hardware Description
Page 3
LED Indicators
The following table provides descriptions of the LED status and
their meaning.
LED Color Status Description
GREE
100/ACT
N
GREE
1000/ACT
N
ON The port is connecting with 100 Mbps
BLINK Sending/Receiving Packets
ON The port is connecting with 1000
Mbps
BLINK Sending/Receiving Packets
Hardware Installation
Follow the instruction given below to install the Gigabit Ethernet PCI
Express Card.
1. Turn your computer off and remove the power plug from the
plug socket.
2. Remove the cover from the computer case.
3. Remove the metal cover plate on the rear of a free PCI Express
slot.
4. Insert the card into one free PCI Express slot and screw it firmly
Page 4
on the bracket side.
5. Place the cover back onto the computer.
6. Insert the plug into plug socket.
Driver Installation
For Windows® 2000, XP/2003 32/64 bit
1. Please insert the CD driver bound with Gigabit Ethernet PCI
Express Card into your CD-ROM Drive.
2. At the Windows desktop click Start, then Run.
3. Type D:\PCIe\LAN\setup.exe, then click OK. (Change D:\ to
match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the instructions to
complete the installation to complete the installation.
For Windows® Vista 32/64 bit
1. Please insert the CD driver bound with Gigabit Ethernet PCI
Express Card into your CD-ROM Drive.
2. At the Windows desktop click Start, then Run.
3. Type D:\PCIe\LAN\Vista\setup.exe, then click OK. (Change D:\
Page 5
to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the instructions to
complete the installation to complete the installation.
Page 6
For Windows® 7 32/64 bit
1. Please insert the CD driver bound with Gigabit Ethernet PCI
Express Card into your CD-ROM Drive.
2. At the Windows desktop click Start, then Run.
3. Type D:\PCIe\LAN\Win7\setup.exe, then click OK. (Change
D:\ to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the
instructions to complete the installation to complete the
installation.
Loading...