Page 1
10/100/1000 Mbps
NETWORK PCI EXPRESS
ADAPTER
Quick Installation Guide
DN-10130
Page 2
Product Introduction
This Gigabit Ethernet PCI-Express Card is a high performance 10/100/1000 BASE-T
Ethernet LAN controller which designed by RTL8169E chipset, is perfectly for home and
office use. It provides a low cost solution for connecting to a high speed Local Area Network
with a data transfer rate up to 1000Mbps over a group of 4 twisted pair copper wires to a
distance of maximum 100 meters away. It is 100 times faster than, and yet 100% fully
backward compatible with 10/100BASE-T system, therefore, it can be easily plugged into
almost any existing network with CAT-5 cabling.
Features & Specification
Complies with PCI-Express Revision 1.1
PCI-Express 1-Lane (x1) interface
Supports standard and low profile chassis
A high performance 1000BASE-T Ethernet controller card
Backward compatible to 10/100BASE-T networking
10/100/1000Mbps data rate auto negotiation operation
Compatible to existing CAT-5 UTP cabling
Fully compliant with IEEE802.3,IEEE802.3u, IEEE802.3ab
Supports half / full duplex mode and 802.3x Flow Control
Supports IEEE802.1P Layer2 Priority Encoding
Supports IEEE 802.1Q VLAN tagging
Crossover Detection and Auto Correction operation
Supports power down/link down power saving
Remarks
Low profile version is available
System Requirements
Windows® 2000, XP/2003/Vista /Win7/8/10 (32/64 bit)
PCI Express-enabled system with an available PCI Express slot
Page 3
Package Contents
(1)
(1)
(2)
(2)
1 x PCIe Gigabit Ethernet Card
1 x User Manual
1 x Driver CD
Hardware Description
100 Link/Active LED
1000Mbps Link
LED Indicators
The following table provides descriptions of the LED status and their meaning.
LED Color Status Description
ON The port is connecting with 100 Mbps
100/Active Green
BLINK Sending/Receiving Packets
1000Mbps Green ON The port is connecting with 1000 Mbps
Page 4
Installation
1. Install the Product into your computer.
2. Please insert the CD driver bound with Gigabit Ethernet PCI Express Card into your
CD-ROM Drive.
3. Access the CD ROM Folder and Start the Installation Program.
4. Follow the on-screen instructions to complete the instructions to complete the
installation to complete the installation.
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the
requirements of Directive 2014/30/EU and the Directive 2011/65/EU for RoHS compliance. The
complete declaration of conformity can be requested by post under the below mentioned
manufacturer address.
Warning:
This device is a class B product. This equipment may cause some radio interference in living
environment. In this case, the user can be requested to undertake appropriate measures to prevent
interference.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
Loading...