FreqOut |
Natural Feedback Creator
HOW IT WORKS:
Momentary Switch:
Sets the operation of the
Footswitch. When set to the
“ON” position, the feedback
eect will only be enabled
as long as the Footswitch is
held down.
When set to the “OFF”
position, the feedback
eect will toggle between
enabled and bypassed
modes each time the
Footswitch is pressed.
Feedback LEDs:
These LEDs light from
the center LED out as the
feedback signal increases.
The rate of feedback is
controlled by the Onset
knob.
Dry Switch:
Turns the dry signal
path on or o when the
feedback eect is enabled.
Power Supply Connector:
Connect a Harman PS0913DC
power supply (sold separately)
to this connector.
Gain Knob (center):
Controls the amount of
feedback signal that is mixed
in with the dry guitar signal.
Onset Knob (ring):
Sets the time it takes for the
feedback to begin after an
input note is detected.
Type Knob:
Select from one of seven
feedback harmonic types
Input 1:
Connect your instrument to
this jack.
Output:
Connect this output to the
input of a another pedal
or the input of your guitar
amp
Footswitch
Turns the eect on or o. This Footswitch can be
congured for momentary or latched operation
using the MOMENTARY switch.
Placement of the FreqOut:
We recommend making it the rst pedal in your
eects signal chain.
Setup of the FreqOut:
Set MOMENTARY to ON. Set DRY to OFF. Set GAIN and
ONSET to 12:00. Set TYPE to 3RD. Press and hold the
Footswitch to enable feedback. Release to stop feedback.
Loading...