Digital Watchdog DWC-V2262D User Manual

5436 W Crenshaw Street

5436 W Crenshaw Street Tampa, FL 33634

Tampa, FL 33634 www.digital-watchdog.com

www.digital-watchdog.com Technical Support : 1-866-446-3595 / 813-888-9555

Technical Support : 1-866-446-3595 / 813-888-9555

INSTRUCTION MANUAL

V2262D Series

About manual

Before installing and using the camera, please read this

Before installing and using the camera, please read this manual carefully.

manual carefully. Be sure to keep it handy for future reference.

PRECAUTIONS

g

■ Do not open or modify

Before installing and using the camera, please read this manual

Do not open the case except during maintenance and installation,

carefully.

as it may be dangerous and cause damages.

Be sure to keep it handy for later reference.

■ Do not put objects inside the unit

Make sure that no metal objects or flammable substances

UNPACKING

get inside the camera. It could cause fire, short-circuits or damages.

■ Be careful when handling the unit

Care should be taken when the unpacking the shipped unit.

To prevent damage, do not drop the camera or subject it to

Check the parts list and confirm all items are included in.

strong shock or vibration.

Contact … .. If a problem is noted.

■ Install away from electric or magnetic fields

■ Protect from humidity and dust

■ Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen or boiler

Be careful when installing close to the ceiling , in a kitchen or boiler room, as the temperature may rise to high levels.

room, as the temperature may rise to high levels.

■ Cleaning

Dirt can be removed from the case only by wiping it with a soft cloth

Dirt can be removed from the case only by wiping it with a soft cloth moistened with a soft deter

moistened with a soft detergent solution.

■ Mounting Surface

The mounting surface material must be strong enough to support the camera.

ent solution.

TROUBLESHOOTING

Before sending the camera out for repair, check the items below.

Before sending the camera out for repair, check the items below. If the problem persists after checking these items, contact your service

If the problem persists after checking these items, contact your service center.

center.

■ If no image appears

Is the coaxial cable attached securely?

Is the coaxial cable attached securely? Are the power and voltage normal?

Are the power and voltage normal? Has the iris of the lens inside the camera been

Has the iris of the lens inside the camera been adjusted correctly (with the level volume) ?

adjusted correctly (with the level volume) ? Is there adequate illumination?

Is there adequate illumination?

■ If the image is unclear

Is the lens in focus?

Is the lens in focus? Is the lens dirty?

Is the lens dirty? Dirt or fingerprints on the lens can adversely affect the

Dirt or fingerprints on the lens can adversely affect the images. Gently wipe any dirt or fingerprints off the lens

images. Gently wipe any dirt or fingerprints off the lens with a soft cloth or lens cleaning paper and cleaning

with a soft cloth or lens cleaning paper and cleaning fluid (commercially available).

fluid (commercially available). Is the monitor adjusted correctly?

WARNING: TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

DIMENSION (mm)

INSTALLATION

F

E

G

D

A

B

H

C

INSTALLATION (cont.)

A. Cut the hole in the ceiling for routing the cables.

B. Loosen the screws from the dome cover.

C. Detach the dome cover from bottom case.

D. Loosen the screws and separate the gimbal.

E. Align the camera unit with the surface of the ceiling, make 3 marks, and

E. Align the camera unit with the surface of the ceiling, make 3 marks, and then drill the holes.

then drill the holes.

F. Pass the power cable and video cable through the cable hole in the ceiling.

G. Match the holes of camera unit with the holes in the ceiling and then fix the

G. Match the holes of camera unit with the holes in the ceiling and then fix the camera unit by tightening screws.

camera unit by tightening screws.

H. Set the gimbal in desired position and tighten the screw.

I. Carry out the settings and adjustment for the camera.

J. Assemble dome cover with bottom case.

K. Tighten the screws back on the dome cover.

CONNECTION

DC12V

CAUTION :

Check for polarity when using a DC 12V power supply.

LENS ADJUSTMENT

B. Focus lever

A. Zoom Lever

A. Set the zoom level to the desired position by moving Zoom lever. B. Set the Focus by moving Focus lever.

WARRANTY INFORMATION

Digital Watchdog (referred to as “the Warrantor”) warrants the Camera

Series against defects in materials or workmanship as follows:

LABOR: For the initial five (5) years from the date of original purchase, if the

camera is determined to be defective, the Warrantor will repair or replace the

camera is determined to be defective, the Warrantor will repair or replace the unit, with

unit, with new or refurbished product at its option, at no charge.

new or refurbished product at its option, at no charge.

PARTS: In addition, the Warrantor will supply replacement parts for the initial

five (5) years.

To obtain warranty or out of warranty service, please contact a Technical

Support Representative at 1-866-446-3595 Monday through Friday from 9:00

AM to 5:00 PM Eastern.

A purchase receipt or other proof of the date of the original purchase is

A purchase receipt or other proof of the date of the original purchase is required before warranty service is rendered. This warranty only covers

required before warranty service is rendered. This warranty only covers failures due to defects in materials and workmanship which arise during

failures due to defects in materials and workmanship which arise during normal use. This warranty does not cover damage which occurs in shipment or failures which are caused by products not supplied by the Warrantor or failures which result from accident, misuse, abuse, neglect, mishandling, misapplication, alteration, modification, faulty installation, set-up adjustments, improper antenna, inadequate signal pickup, maladjustment of consumer controls, improper operation, power line surge, improper voltage supply, lightning damage, rental use of the product or service by anyone other than an authorized repair facility or damage that is attributable to acts of God.

LIMITS A ND EXCLUSIONS

There are no express warranties except as listed above. The Warrantor will

There are no express warranties except as listed above. The Warrantor will not be liable for incidental or consequential damages (including, without

not be liable for incidental or consequential damages (including, without limitation, damage to recording media) resulting from the use of these

limitation, damage to recording media) resulting from the use of these products, or arising out of any breach of the warranty. All express and implied

products, or arising out of any breach of the warranty. All express and implied warranties, including the warranties of merchantability and fitness for

warranties, including the warranties of merchantability and fitness for particular purpose, are limited to the applicable warranty period set forth

particular purpose, are limited to the applicable warranty period set forth above.

above.

Some states do not allow the exclusion or limitation of incidental or

Some states do not allow the exclusion or limitation of incidental or consequential

consequential damages, or limitations on how long an implied warranty lasts, so the above

damages, or limitations on how long an implied warranty lasts, so the above exclusions or limitations may not apply to you. This warranty gives you

exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights that vary from state to

specific legal rights and you may also have other rights that vary from state to state.

state.

If the problem is not handled to your satisfaction, then write to the Address

If the problem is not handled to your satisfaction, then write to the Address above.

above.

Service calls which do not involve defective materials or workmanship as determined by the Warrantor, in its sole discretion, are not covered. Costs of such service calls are the responsibility of the purchaser.

Model V2262D Camera TYPE Color Anti-Vandal Digital Dome Camera

Mount Surface

Image Device Super HAD CCD

Size 1/3" Pixels-Total 537(H) x 505(V) Pixels-Effective 510(H) x 492(V)

Scanning System 525 line, 2:1Interlace

Horizontal Frequency Internal Mode 15,734Hz

Vertical Frequency Internal Mode 59.94Hz Min. Scene Illumination F1.5 0.2 Lux Functions(Programmable) AM/ME AM/ME Mode

Flicker less ON / OFF

AWB ATW / AWB

BLC ON/OFF

AGC ON/OFF Lens Focal Length 3.3 ~ 12mm Resolution Horizontal 420 TV Lines Video Output VBS 1.0Vp-p VBS 1.0Vp-p(75 Load) S/N Ratio S/N Ratio 48dB OSD OSD NO Environmental Conditions Operating Temperature

Humidity Less than 90% Power Power Requirement 12VDC

Power Consumption DC12 [V]: 86[mA] Physical Specification Dimensions(φ x H) 112 x 78.3mm

-10℃ ~ +55℃(14℉ ~ 131℉)

Digital Watchdog DWC-V2262D User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual