Analog High Definition
Micro Dome Camera
DWC-MC753WTIR
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
04172015
PRECAUTIONS
Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages.
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera.
It can cause fire, short-circuits, or other damages.
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of kitchen or a boiler room,
as the temperature may rise to high levels.
Cleaning:
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface:
The material of the mounting surface must be strong enough to support the camera.
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference, when the equipment is operated in a residential environment. This
equipment generates, uses, and radiates radio frequency energy; and if it is not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
WARNING: Changes or modifications are not expressly approved by the manufacturer.
2
TABLE OF CONTENTS
Introduction
Features
Parts and Descriptions
Dimensions
4
5
6
Installation
Troubleshooting
Warranty Information
Specifications
Inside the Box
Mount Installation Instructions
Connecting to Monitors
Adjusting the Camera’s Position
7
8-9
10
11
12
13-14
15
3
FEATURES*
Analog High Definition (AHD) HD over Coax Technology
STAR-LIGHT™ Super Low Light Technology
Panasonic 1/3" CMOS Sensor
1080P Resolution at 30fps
Wide Dynamic Range (WDR)
Fixed Lens 3.6mm
Smart IR™ with Intelligent Camera Sync. 50ft Range
Smart DNR™ 3D Digital Noise Reduction
Highlight Masking Exposure (HME)
True Day/Night Mechanical IR Cut Filter
Secondary Video-BNC Output
Programmable Privacy Zones
Auto Gain Control (AGC)
Back Light Compensation (BLC)
Auto White Balance (AWB)
IP66 Certified (Weather Resistant)
4
PARTS & DESCRIPTION*
Lens
1
2
Power Input Connector
12VDC Voltage
3
Primary Video BNC Output Connector
4
Mounting Screws
5
Camera Module
6
Bubble Dome
7
Upper Case
8
Security Screw
8
6
7
4
1
5
2
3
5
DIMENSIONS IN MILLIMETERS (IN)*
6
INSIDE THE BOX*
Included with Micor Indoor Dome Camera
1
User Manual
2
Mounting Template
3
4 Machine Screw and 4 Dry Wall Anchors
Analog High Definition
Micro Dome Camera
DWC-MC753WTIR
ABOUT MANUAL
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
04172015
4
Miniature L-Key for Security Screw
5
L-Key
7
INSTALLATION*
1
1. Remove the Security Screw from the Upper
Case using the small L-Key.
2. Unscrew the upper case from the camera
module by rotating it counter clock-wise.
3. Use the camera’s mounting template or your
4
camera to mark the holes as required. Drill into
the drywall and insert the drywall mounts into
the holes.
4. Pull wires through and make connections.
(See page 10 for more information).
Mount the camera to the wall using the
included machine screws.
8
2
3
INSTALLATION*
5
6
5. Adjust the camera’s view (See page 11 CAMERA SETTINGS).
6. place the bubble dome on the camera.
Screw the cover dome back by rotating it
clock-wise.
7. Tighten the Security screw back in place to
firmly secure the cover dome to the camera
module.
7
3
CONNECTIONS*
Use the diagram below to connect the camera to a Monitor or
CRT Monitor properly.
12VDC VIDEO OUT
CAUTION :
Check for polarity when using a DC 12V.
8
ADJUSTING THE CAMERA GIMBAL*
Adjust the camera’s pan (360º) and tilt (70º) position.
Rotation 360º
1
Tilting 70º IR LED
3
Panning 360º
2
3
TROUBLESHOOTING
Before sending your camera for repair, check the following or contact our technical
specialist.
FOR NO VIDEO
Check the coaxial cable and make sure it is connected securely.
Check the lens’ iris adjustment at the camera’s OSD menu.
Check the power supply and make sure the camera has the proper voltage and
current.
FOR OUT-OF-FOCUS VIDEO
Check the clear dome cover and the lens for dirt or fingerprints. Use a soft cloth and
gently clean. Check the lens’ manual focal and zoom adjustment. The use of a field
test monitor is recommended.
8
WARRANTY INFORMATION*
Digital Watchdog (referred to as “the Warrantor”)
warrants Camera Series against defects in
materials or workmanship as follows.
LABOR : For the initial five (5) years and one (1) year on LED
from the date of original purchase, if the camera is determined to be defective,
the Warrantor will repair or replace the unit, with new or refurbished
product at its option, at no charge.
PARTS : In addition, the Warrantor will supply
replacement parts for the initial five (5) years and one (1) year on LED.
To obtain warranty or out of warranty service,
please contact a Technical Support Representative at
1-866-446-3595 Monday through Friday from 8:30AM to 8:00PM Eastern.
A purchase receipt or other proof of the original purchase date is required
before warranty service is rendered. This warranty only covers failures due to
defects in materials and workmanship which arise during normal use.
This warranty does not cover damage that occurs in shipment or failures
caused by products not supplied by the Warrantor or failures
which result from accident, misuse, abuse, neglect, mishandling,
misapplication, alteration, modification, faulty installation, set-up adjustments,
improper antenna, inadequate signal pickup, maladjustment of consumer controls,
improper operation, power line surge, improper voltage supply, lightning damage,
rental use of the product or service by anyone other than an authorized repair
facility or damage that is attributable to acts of God.
3
LIMITS AND EXCLUSIONS*
There are no express warranties except as listed above.
The Warrantor will not be liable for incidental or consequential
damages (including without limitation and damage to recording media)
resulting from the use of these products, or arising out of any breach
of the warranty. All express and implied warranties, including the
warranties of merchantability and fitness for particular purpose,
are limited to the applicable warranty period set forth above.
Some states do not allow the exclusion or limitation of incidental
or consequential damages, or limitations on how long an implied
warranty lasts, so the above exclusions or limitations may not
apply to you. This warranty gives you specific legal rights, and you
may also have other rights that vary from state to state.
If the problem is not handled to your satisfaction,
then write to the Address listed on the back page.
Service calls which do not involve defective materials or
workmanship as determined by the Warrantor in its sole
discretion are not covered. Costs of such service calls are
the responsibility of the purchaser.
8
SPECIFICATIONS*
VIDEO
Image Sensor Panasonic 1/3" CMOS
Active Pixels 1944(H) x 1092(V)
Scanning System Progressive scan
Frequency 60Hz/50Hz
Signal Technology 2.0 Megapixel AHD
Synchronization Internal
Resolution 1920x1080 (1080p)
Minimum Scene Illumination F1.4 (30IRE): 0.35Lux [Color]
F1.4 (30IRE): 0 Lux [B&W]
S/N Ratio 55dB
Video Output AHD 1080p30fps/720p60fps/720p30fps
LENS
Focal Length 3.6mm
Lens Type Fixed Lens
IR Distance 50ft
ELECTRICAL
Power Requirements / Consumption DC12V: 2.15W, 179mA, LED ON: 3.64W, 303mA
MECHANICAL
Housing Material and Dimensions Aluminum, 234.5 x 82.2 mm (9.23 X 3.23 in)
Weight 1.65lbs
3
5436 W Crenshaw St. Tampa, FL 33634
Tel : 866-446-3595 / 813-888-9555
Fax : 813-888-9262
www.Digital-Watchdog.com
technicalsupport@dwcc.tv
Technical Support Hours : Monday-Friday
9:00am to 8:00pm EST
Loading...