Digital Watchdog DWC-D2252DIR, DWC-D2362DIR, DWC-D2262DIR, DWC-D2363D, DWC-D2363TIR User Manual
...
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.
ABOUT MANUAL
12232010
User Manual
Indoor Dome Camera
DWC-D2252DIR, D2262DIR, D2362DIR
DWC-D2363D, D2363TIR
DWC-D2367WD, D2367WTIR
GG
Do not open or modify.
GG
Do not open the case except during maintenance and installation,
for it may be dangerous and can cause damages.
G
Do not put objects into the unit.
GGGG
or other damages.
GGG
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of a kitchen or a boiler room, as the temperature may rise to
high levels.
Cleaning
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface
The material of the mounting surface must be strong enough to support the camera.
GGGGGGGGGGGGGGGGGGGGGGGGGGG
PRECAUTIONS
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference, when the equipment is operated
in a residential environment. This equipment generates, uses,
and radiates radio frequency energy; and if it is not installed and used in accordance with the instruction
manual, it may cause harmful interference to radio communications.
WARNING
:
C
hanges or modications are not expressly approved by the manufacturer.
FCC COMPLIANCE
2
Before sending your camera for repair, check the following or contact our technical specialist.
No Video
Check the coaxial cable and make sure it is connected securely.
Check the lens’ iris adjustment at the menu setup
of the camera.
Check the power supply and make sure the camera has the proper voltage and current.
Out-of-Focus Video
Check the lens manual focal and zoom adjustment. Field test monitor is recommended.
TROUBSHOOTING
3
4
1/3” Sony Super HAD II CCD
420 TV Lines
3.6mm Fixed Lens (D2252DIR)
3.3 ~ 12m Varifocal Auto Iris Lens (D2262DIR)
100ft Range IR with Intelligent Camera Sync
Electronic Day and Night
DRC (Dynamic Range Compressor)
HME (Highlight Masking Exposure)
SLC (Side Light Compensation)
AGC / BLC / AWB
Negative Imaging
Mirror Image Control
Programmable Privacy Zone (4) & Motion Detection
Easy Icon Driven OSD Menu with Built-in Joystick
Auto Sensing 12VDC/24VAC with Line Lock
12VDC Transformer Included
Secondary Video-BNC Output
FEATURES
*
-
D2252DIR, D2262DIR
5
FEATURES
*
-
D2362DIR
1/3” Sony Super HADIICCD
540 TV Lines
3.3 ~ 12mm Varifocal Auto Iris Lens
100ft Range IR with Intelligent Camera Sync
Electronic Day and Night
DRC (Dynamic Range Compressor)
HME (Highlight Masking Exposure)
SLC (Side Light Compensation)
AGC / BLC / AWB
Negative Imaging
Mirror Image Control
12VDC Transformer Included
Programmable Privacy Zone (4) & Motion Detection
Easy Icon Driven OSD Menu with Built-In Joystick
Secondary Video-BNC Output
FEATURES
*
-
D2363D
1/3" Sony Super HAD II CCD560 TV Lines
3.3~12mm Varifocal Auto Iris Lens
Electronic Day and Night
Star-Light (Super Low Light Technology)
DRC (Dynamic Range Compressor)
3D-DNR (3D Digital Noise Reduction)
HME (Highlight Masking Exposure)
6
FEATURES
*
-
D2363TIR
1/3” Sony Super HAD II CCD
High Resolution 560 TV Lines
3.3 ~ 12mm Varifocal Auto Iris Lens
100ft Range IR with Intelligent Camera Sync
True Day and Night / TDN5
Star-Light (Super Low Light Technology)
DRC (Dynamic Range Compressor)
3D-DNR (3D Digital Noise Reduction)
HME (Highlight Masking Exposure)
AGC / BLC / AWB
Programmable Privacy Zone (8) & Motion Detection
Easy Icon Driven OSD Menu with Built-in Joystick
Auto Sensing 12VDC/24VAC with Line Lock
Secondary Video-BNC Output
BLC (Back Light Compensation)
Programmable Privacy Zone (8) & Motion Detection
Easy Icon Driven OSD Menu with Built-in Joystick
Auto Sensing 12VDC/24VAC with Line Lock
Secondary Video-BNC Output
7
FEATURES
*
-
D2367WD
1/3” Sony Super HAD II CCD
560 TV Lines
3.3 ~ 12mm Varifocal Auto Iris Lens
Electronic Day and Night
EWDR (Electronic Wide Dynamic Range)
Star-Light (Super Low Light Technology)
DSS (Digital Slow Shutter)
3D-DNR (3D Digital Noise Reduction)
DIS (Digital Image Stabilizer)
HME (Highlight Masking Exposure)
AGC / BLC / AWB
Programmable Privacy Zone (6) & Motion Detection
Easy Icon Driven OSD Menu with Built-in Joystick
Auto Sensing 12VDC/24VAC with Line Lock
Secondary Video-BNC Output
8
FEATURES
*
-
D2367WTIR
1/3” Sony Super HAD II CCD
560 TV Lines
3.3 ~ 12mm Varifocal Auto Iris Lens
100ft Range IR with Intelligent Camera Sync
True Day and Night / TDN5
EWDR (Electronic Wide Dynamic Range)
Star-Light (Super Low Light Technology)
DSS (Digital Slow Shutter)
3D-DNR (3D Digital Noise Reduction)
DIS (Digital Image Stabilizer)
HME (Highlight Masking Exposure)
AGC / BLC / AWB
Programmable Privacy Zone (6) & Motion Detection
Easy Icon Driven OSD Menu with Built-in Joystick
Auto Sensing 12VDC/24VAC with Line Lock
Secondary Video-BNC Output
9
DIMENSION (mm)
*
109.6
103.1
41.3
6.5
145
117.0
125.0
5.0
4.5
91.0
91.0
85.0
85.0
L= 300mm
RS485 (Black+ & White -)
VIDEO (YELLOW)
BNC JACK
DC 12V or AC24V
5mm TWIST SOLDERING
RED
BLACK
10
Power Requirement *
Power Wire Maximum Distance
Wire Gauge 12VDC 24VAC
24 AWG 80ft 323ft
22 AWG 128ft 513ft
20 AWG 203ft 815ft
18 AWG 323ft 1295ft
16 AWG 514ft 2056ft
14 AWG 816ft 3264ft
12 AWG 1295ft 5183ft
10 AWG 2057ft 8228ft
Coaxial Cable Type Maximum Distance
RG59/U 750ft
RG6/U 1,000feet
RG11/U 1,500feet
Power Requirement
12VDC at 1A
24VAC at 500mA
11
INSTALLATION
*
Included with Digital Watchdog Camera:
1. User Manual
2. Mounting Template
3. Security L-Key
4. Single Sided Hex Key
5. Secondary BNC Cable for a Field Monitor
6. Four (4) Screws and Four (4) Dry Wall
Anchors
X
Z
Y
[
\
^
]
Camera Installation
Use the Mounting Template (2) when mounting the camera.
Use the Security L-Key (3) to loosen the Four Screwsthat secure the vandal-proof dome cover.
Remove the cover; then, remove the inner screw holes to mount the camera.
NOT
E
Loading...