Digital Watchdog DWC-B362DIR User Manual

DWC-B362DIR
Digital Bullet Camera

User Manual

ABOUT MANUAL

Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for future reference.

01312011

PRECAUTIONS

Do not open or modify.
Do not open the case except during maintenence and installation,
for it may be dangerous and can cause damages.
Do not put objects into the unit.
Keep metal objects and flammable substances from entering the camera. It can cause fire, short-circuits,
or other damages.
Be careful when handling the unit.
To prevent damages, do not drop the camera or subject it to shock or vibration.
Do not install near electric or magnetic fields.
Protect from humidity and dust.
Protect from high temperature.
Be careful when installing near the ceiling of kitchen or a boiler room, as the temperature may rise to
high levels.
Cleaning
To remove dirt from the case, moisten a soft cloth with a soft detergent solution and wipe.
Mounting Surface.
The material of the mounting surface must be strong enough to support the camera.

FCC COMPLIANCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These limits are designed to Provide reasonable protection against harmful
interference. when the equipment is operated in a residential environment. This equipment generates, uses,
and radiates radio frequency energy; and if it is not installed and used in accordance with the instruction
manual, it may cause harmful interference to radio communications.

WARNING : Changes or modifications are not expressly approved by the manufacture.

22

TROUBLESHOOTING

Before sending your camera for repair, check the following or contact our technical specialist.

No VIDEO

Check the coaxial cable and make sure it is connected securely.
Check the lens’ iris adjustment at the menu setup of the camera.
Check the power supply and make sure the camera has the proper voltage and current.

Out-of-Focus VIDEO

Check the clear dome cover and the lens for dirt or fingerprints. Use a soft cloth and gently clean.
Check the lens manual focal and zoom adjustment. Field test monitor is recommended.

3

DIMENSIONS IN MILLIMETERS*

4

CONTROL BOARD*

SW

CON 1

FUNCTIONAL OF CONTROL BOARD

[1] SW : Functional control of OSD (On Screen Display)

[2] CON 1 :Second Video Output Connector

5

CONNECTIONS*

CAUTION :
Check for polarity when using a DC 12V & AC 24V power supply.

6

CAMERA SETTING ANGLE*

①

②

ATTENTION

Do not rotate ① more than 360°

Do not unnecessarily twist ② too many times.

7

OSD MENU SETTINGS*

EXPOSURE

LENS DC / MANUAL

SHUTTER 1/160, 1/100, FLC, 1/250 ~ 100000

BLC

AGC OFF ~ 36dB

EXIT JUMP

WB MODE AWC / A TW / PUSH LOCK / MANUAL (AWC is recommended.)

R - Y GAIN 0 ~ 255

B - Y GAIN 0 ~ 255

EXIT JUMP

DAY&NIGHT MODE AUTO / COLOR / BW

EXIT JUMP

MIRROR OFF / ON

SHARPNESS 0 ~ 49

GAMMA 0.05 ~ 1.00 / USER

SLC

HME

DRC

EXIT JUMP

8

OFF / ON

BLC (Back Lignt Compensation)

COLOR

DAY&NIGHT

FUNCTION

OFF / ON

SLC (Side Light Compensation)

OFF / ON

HME (Highlight Masking Exposure)

OFF / ON

DRC (Dynamic R

ange Compressor)

MASK 2

MOTION

EXIT JUMP

MASK 1

MASK 3

MASK 4

COLOR SET

EXIT JUMP

MOTION

OFF / ON

SET WINDOW

ALL SET (Set the Entire Sc reen)

ALL CLEAR (Clear the Entire Screen)

SENSITIVITY (0 ~ 55)

SHOW INDICATOR (OFF / Icon / TRACE)

DELAY OUT (1 ~ 15)

Motion Alarm Zoom-In Delay

PRIVACY

OFF / ON

SET WINDOW

OFF / ON

SET WINDOW

OFF / ON

SET WINDOW

OFF / ON

SET WINDOW

BLACK / GRAY / COLOR 1 ~ 6

9

SETUP

DPC SET

CAMERA ID

TITLE EDIT

TITLE RESET

TITLE POS.

LANGUAGE

PC CONT.

EXIT JUMP

EXIT

EXIT

SAVE & EXIT

FACTORY SET

0 ~ 255

TOP_L/TOP_R/BOT_L/BOT_R

OFF / ON

WHITE THR. 0~255

BLACK THR. 0~255

DPC LEVEL. 0~255

English, Chinese

OFF / ON

10

WARRANTY INFORMATION*

Digital Watchdog (referred to as “the Warrantor”)
warrants Camera Series against defects in
materials or workmanship as follows.

LABOR : For the initial two (2) years from the date of original purchase,
if the camera is determined to be defective,
the Warrantor will repair or replace the unit, with new or refurbished
product at its option, at no charge.

PARTS : In addition, the Warrantor will supply
replacement parts for the initial two (2) years.

To obtain warranty or out of warranty service,
please contact a Technical Support Representative at
1-866-446-3595 Monday through Friday from 8:30AM to 8:00PM Eastern.

A purchase receipt or other proof of the original purchase date is required
before warranty service is rendered. This warranty only covers failures due to
defects in materials and workmanship which arise during normal use.
This warranty does not cover damage which occurs in shipment or failures
which are caused by products not supplied by the Warrantor or failures
which result from accident, misuse, abuse, neglect, mishandling,
misapplication, alteration, modification, faulty installation, set-up adjustments,
improper antenna, inadequate signal pickup, maladjustment of consumer controls,
improper operation, power line surge, improper voltage supply, lightning damage,
rental use of the product or service by anyone other than an authorized repair
facility or damage that is attributable to acts of God.

11

LIMITS AND EXCLUSIONS*

There are no express warranties except as listed above.
The Warrantor will not be liable for incidental or consequential
damages (including, without limitation, damage to recording media)
resulting from the use of these products, or arising out of any breach
of the warranty. All express and implied warranties, including the
warranties of merchantability and fitness for particular purpose,
are limited to the applicable warranty period set forth above.

Some states do not allow the exclusion or limitation of incidental
or consequential damages, or limitations on how long an implied
warranty lasts, so the above exclusions or limitations may not
apply to you. This warranty gives you specific legal rights, and you
may also have other rights that vary from state to state.

If the problem is not handled to your satisfaction,
then write to the Address listed on the next page.

Service calls which do not involve defective materials or
workmanship as determined by the Warrantor, in its sole
discretion, are not covered. Costs of such service calls are
the responsibility of the purchaser.

12

ON / OFF

80.6 x 251.2mm

SPECIFICATIONS*

Model

Camera TYPE Color/BW

Image Device

Scanning System 525 line , 2:1Interlace 625 lin e, 2:1Interlace

Min. Scene Illumination IR-LED on

OSD Controls BLC

Lens Focal Length

Resolution Horizontal

Video Output VBS 1.0Vp-p

S/N Ratio S/N Ratio

Environmental Conditions Operating Tem perature

Power Power Requirem ent

Physical Specification Dim ensions (H x L)

Pixels-Total 811(H) x 508(V) 795(H) x 596(V)

Pixels-Effective 768(H) x 494(V) 752(H) x 582(V)

Horizontal Frequen cy Internal Mode 15,734Hz( =NTSC ) 15,625Hz( =PAL )

Horizontal Frequen cy Line-Lock Mode 15,750Hz( =NTSC ) 15,625Hz( =PAL )

Vertical Frequency Internal Mode 59.94Hz( =NTSC ) 50Hz( =PAL )

Vertical Frequency Line-

Mirror

SLC

HME

DRC

Motion Detection

Privacy Zone

Humi dity

Power Cons umption

Nema Type

Specifica tions

Lock Mode 60Hz( =NTSC ) 50Hz( =PAL )

B362DIR

1/3" Super HAD II CCD

0.0 Lux

ON / OFF

ON / OFF

ON / OFF

ON / OFF

ON / OFF (Area / Sensitivity )

4 Program mable Zone / Size

3.3 ~ 12mm (3.6x Optical)

520 TV Lines [at TDN (B/W) :560 TV Lines ]

VBS 1.0Vp-p(75 Loa d)

50dB

-10℃ ~ +55℃(14℉ ~ 131℉)

Less then 90%

12VDC / 24VAC

DC12 [V] LED off : 1.7 [W]

DC12 [V] LED on : 4.1 [W]

AC24 [V] LED off : 2.2 [W]

AC24 [V] LED on : 4.1 [W]

IP66

Ture Day/Night Digital Bullet IR Camera

13

5436 W Crenshaw St. Tampa, FL 33634

Tel : [phone]

Fax : [phone]

www.Digital-Watchdog.com

[e-mail]

Technical Support Hours : Monday-Friday

8:30am to 8:00pm Eastern Time