Digi Connect DC-ES-4SB, Connect DC-ES-8SB, Connect DC-ES-4SB-SW, Connect DC-ES-8SB-SW Hardware Setup Manual
Digi Connect
®
ES
Device Server
Hardware setup guide
Digi Connect ES Device Server Hardware setup guide
90001925
Revision Date Description
A June 2014 Revised and replaced document 90000715-88_D to comply with IEC
60601-1 documentation requirements.
Disclaimers
Information in this document is subject to change without notice and does not represent a commitment on
the part of Digi International. Digi provides this document “as is,” without warranty of any kind, expressed
or implied, including, but not limited to, the implied warranties of fitness or merchantability for a particular
purpose. Digi may make improvements and/or changes in this manual or in the product(s) and/or the
program(s) described in this manual at any time.
Trademarks and copyright
Digi, Digi International, Digi Connect, and the Digi logo are trademarks or registered trademarks in the United
States and other countries worldwide. All other trademarks mentioned in this document are the property of
their respective owners.
© 2014 Digi International. All rights reserved.
Customer support
If you need assistance, contact technical support:
Telephone (8:00 am - 5:00 pm—U.S. Mountain Time):
866.765.9885 toll-free U.S.A. & Canada
801.765.9885 Worldwide
Fax: 952.912.4952
Online: www.digi.com/support
Email: tech.support@digi.com
Mail:
Digi International
11001 Bren Road East
Minnetonka, MN 55343
USA
Digi Connect ES Device Server Hardware setup guide 2
Contents
About Digi Connect ES Device Server
Technical description 5
Digi Connect ES Device Server models 5
Additional information 6
Recycling and disposal 6
Environmental information 6
Symbol definitions 7
Cautions and warnings 8
Connectors, LEDs, and controls 9
Setting up Digi Connect ES Device Server hardware
Before setting up the hardware 11
EMC specification 11
Setting up Digi Connect ES hardware 12
Digi Connect ES Device Server Hardware setup guide 3
Digi Connect ES Device Server Hardware setup guide 4
About Digi Connect ES Device Server
Digi Connect ES Device Server is a high performance, high-reliability serial-to-Ethernet
concentrator with extended safety characteristics.
Technical description
Digi Connect ES provides serial-over-Ethernet connectivity to connect sensitive RS-232-enabled
devices to the network. Both serial and Ethernet ports are galvanically isolated, and Ethernet
ports offer 10/100 Mbps network interface with an optional Ethernet switch.
Digi Connect ES is intended for data collection and information management, either directly or
through networks with independent devices. Digi Connect ES does not provide alarm or safety
notification capabilities and is not to be used in the critical path between any device and any
alarm or safety notification system.
Digi Connect ES Device Server models
This guide pertains to all Digi Connect ES Device Server models:
Base model
DC-ES-4SB DC-ES-4SB-?? Digi Connect ES 4SB (4 ports)
DC-ES-8SB DC-ES-8SB-?? Digi Connect ES 8SB (8 ports)
DC-ES-4SB-SW DC-ES-4SB-SW-?? Digi Connect ES 4SB with Switch (4 ports)
DC-ES-8SB-SW DC-ES-8SB-SW-?? Digi Connect ES 8SB with Switch (8 ports)
Digi Connect ES products are compliant with IEC 60601-1 3rd edition.
Digi Connect ES is intended for use as an ITE device for data transmission only. No data
modification takes place within the device.
Digi Connect ES Device Server Hardware setup guide 5
Regional
model variants Description
Loading...