DFI KS150, KS190, KS215-SD, KS-SD Series Installation Manual
KS150/190/215-SD Installation Guide
Package Contents
•
One 15", 19", or 21.5" Modular Touch Panel PC
•
3-pin Terminal Blcok Connector
•
SATA and Mini PCIe Installation Screws
DFI reserves the right to change the specications at any time prior to the
product's release. For the latest revision and more details of the installation
procedure, please refer to the user's manual on the website.
www.d.com
1
Panel
Bottom View
Power Button
Remote Power Switch
Status LED (Orange)
HDD LED (Red)
COM 2
COM 3
Reset Button
COM 1
COM 4
Top View
DC-in
Front OSD Functions (only for models with front OSD)
Backlight or Power
on/off
Notes on OSD Settings:
The front OSD is capable of controlling the system in the following ways in addition to
its explicit functions.
1. System Power On/Off: Press the Backlight on/off button for 3 seconds.
2. Light Sensor On/Off: Press the Brightness up arrow for 3 seconds.
3. OSD Lock/Unlock: Press the Brightness down arrow for 3 seconds.
4. The Alarm LED has no funtion for the KS-SD Series.
Volume
DVI-D
(DVI-I connector)
VGA
Brightness
USB 3.0
LAN 2
LAN 1
Power HDD Alarm LED
2
Removing the Chassis Cover
1. Make sure the system and all other peripheral devices connected to it
have been powered-off.
2. Disconnect all power cords and cables.
3. The 6 mounting screws on the rear side of the system are used to
secure the cover to the chassis. Remove these screws and put them in a
safe place for later use.
Mounting Screw
4. Lift the cover to open the system.
5. The Mini PCIe, M.2 and the SODIMM slots are readily accessible after
removing the chassis cover.
Mini PCIe
Sockets
SATA drive bay
3
Installing a SATA Drive
The system can accommodate one SATA drive. Please use the following
procedure to install a SATA drive in the system.
1. Before installing the SATA drive, connect the SATA data/power cable
to the SATA data connector of the SATA drive. Then install the SATA
drive onto the HDD bracket with the provided mounting screws.
Mounting Screws
Mounting screws
SATA data and power cable
2. Place the SATA drive installed with the HDD bracket in the system.
Align the mounting holes on the HDD bracket with the mounting holes
on the drive bay and use the provided mounting screws to secure the
drive in place.
Mounting Screws
4
3. Connect the other end of the SATA data/power cable to the SATA data
and power connectors on the system board respectively.
SATA data connector
SATA power connector
5
Loading...