DeWalt DXPW2000E, DXPW3000E, DXPW2500E Instruction Manual

3

English

Definitions: Safety Guidelines

The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to these
symbols.

DANGER: Indicates an imminently hazardous situation which,

if not avoided, will result in death or serious injury.

WARNING: Indicates a potentially hazardous situation which,

if not avoided, could result in death or serious injury.

CAUTION: Indicates a potentially hazardous situation which, if

not avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury

which, if not avoided, may result in property damage.

IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS
CONTACT US AT: www.dewaltpw.com or 1 [phone]

WARNING: Please read this entire manual before attempting

to assemble, operate or install the product.

WARNING: This unit was designed for specific applications. It

should not be modified and/or used for any application other than that
which it was designed.

NOTICE: Always store your pressure washer in a location where
the temperature will not fall below 40°F (4°C). freeze damage is not
covered by the warranty.

WARNING: This product contains chemicals known to the State

of California to cause cancer, and birth defects or other reproductive
harm. In addition, some cleaning products and dust contain chemicals
know to the State of California to cause cancer, and birth defects or
other reproductive harm. Wash hands after handling.

READ AND SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using this product basic precautions should

always be followed, including the following:

1. Read all the instructions before using the product.

2. To reduce the risk of injury, do not operate near children or
animals.

3. Know how to stop the product and bleed pressures quickly.
Be thoroughly familiar with the controls.

4. Stay alert - watch what you are doing.

5. Do not operate the product when fatigued or under the
influence of alcohol or drugs.

6. Keep operating area clear of all persons.

7. Do not overreach or stand on unstable support. Keep good
footing and balance at all times.

8. Follow the maintenance instructions specified in the manual.

9. This product is provided with a Ground Fault Circuit Interrupter
built into the power cord plug. If replacement of the plug or
cord is needed, use only identical replacement parts.

10. Do not touch plug or outlet with wet hands.

11. Avoid accidental starts. Move switch on unit to OFF position
before connecting or disconnecting cord to electrical outlets.

12. Water spray must never be directed towards any electric wiring
or directly towards the pressure washer machine itself or fatal
electric shock may occur.

13. Never carry your pressure washer by the cord. Do not pull on
the cord to disconnect from the outlet.

14. To prevent damage, the cord should not be crushed, placed
next to sharp objects or near a heat source.

15. Check power cords before using. Damaged cords can reduce
performance of pressure washer or cause a fatal electrical
shock.

4

English

16. The narrow pin point stream is very powerful. It is not
recommended for use on painted surfaces, wood surfaces or
items attached with an adhesive backing.

17. Keep operating area clear of all persons and ani mals.

18. Always use both hands when operating pressure washer to
maintain complete control of the wand.

19. Do not touch nozzle or water spray while operating. Never
place hands in front of nozzle.

20. Wear safety goggles while operating. Wear protective clothing
and footwear to protect against accidental spraying.

21. Disconnect power plug from the outlet when not in use and
prior to the detaching of the high pressure hose.

22. Never tie knots or kink the high pressure hose as da mage
could result. Inspect the high-pressure hose regularly. Replace
the hose immediately if it is damaged, worn or shows any signs
of cracks, bubbles, pinholes, or other leakage. Never grasp a
high-pressure hose that is leaking or damaged.

23. Do not operate or store this product in temperatures below
40°F (4°C). Freeze damage is not covered by the warranty.

24. Carefully observe all chemical instructions and warnings before
using. Use only approved pressure washer cleaners. Do not
use bleach, chlorine, or any cleaners containing acids. Always
follow manufacturer’s label recommendations for proper use
of cleaners. Always protect eyes, skin and respiratory system
from cleaners.

25. The pressure washer should not be used in areas where gas
vapors may be present. An electric spark could cause an
explosion or fire.

26. To minimize the amount of water getting into the pressure
washer, the unit should be placed as far as possible from the
cleaning site during operation.

27. To prevent accidental discharge, the spray gun should be
secured by locking the trigger when not in use.

28. To allow free air circulation, the pressure washer should NOT
be covered during operation.

29. Never touch, grasp or attempt to cover a pinhole or similar
water leak on the high-pressure hose. The stream of water IS
under high pressure and WILL penetrate skin.

30. Use only hoses and accessories rated for pressure higher
than your pressure washer's psi. Never use with any other
manufacturer’s accessories or components.

31. Never defeat the safety fea tures of this product.

32. Do not op er ate machine with missing, broken or un au tho rized
parts.

33. Never spray flammable liquids or use pressure washer in areas
containing combustible dust, liquid, or vapors.

34. DO NOT use an extension cord with this pressure washer.

WARNING: Risk of injection or injury. Do not direct discharge

stream at persons.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

MOTOR OVERLOAD

The electric motor in this pressure washer is equipped with an
overload protection device which will automatically shut off the motor
in the event the motor draws excessive current or overheats. Allow
motor to cool and then reset thermal overload button on pump motor.

GROUNDING INSTRUCTIONS

This product must be grounded. If it should malfunction or breakdown,
grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. This product is equipped with a cord
having an equipment-grounding conductor and a grounding plug. The