Desa W32GO User Manual

W32GO Mantel and Base

ASSEMBLY AND INSTALLATION INSTRUCTIONS

IMPORTANT: Read entire instruction sheet before
assembling or installing mantel kit.

These mantels are only approved for use with any
DESA Heating, LLC 32" electric and compact gas

replace system. Do not use mantel with any other

product.

This mantel kit contains the following:

• Mantel pieces - unassembled and numbered as follows:
#1 Base
#2 Right Side Assembly
#3 Left Side Assembly
#4Header
#5 Top
#6 Heat Reector Strip

• Hardware Package
20 - 1 1/4" Wood Screws 114325-01

* Extra hardware may be included

Tools required:

• Power Screwdriver with #2 Phillips Bit

If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement. If
hardware is missing or damaged, contact DESA Heating, LLC
at 1-866-672-6040 for referral information. You can also visit
DESA Heating, LLC's web site at www.desatech.com.

Note: Gather all mantel pieces together before assembling
mantel.

WARNING: Only use 1 1/4" screws to assemble
mantel. Damage to mantel will result if other screws
are used for this purpose.

www.desatech.com

ASSEMBLING MANTEL

IMPORTANT: More than one person is required to lift
assembled mantel. Lift mantel by leg assemblies. Lifting
by header or mantel top could damage mantel.

Use the following illustrations to assemble mantel. Use only
screws provided.

Header #4

Right Leg
Assembly #2

Left Leg
Assembly #3

Header
Assembly
Block

Mantel
Top #5

Assembly
Blocks

11/4"
Screws

Figure 3 - Installing Top

IMPORTANT: Align mantel top left to right before installing.
Back of mantel leg must be ush with back of mantel top
before installation.

11/4"
Screws

Figure 1 - Installing Header

11/4" Screw

Figure 2 - Installing Heat Strip

Header #4

Heat Reector
Strip #6

IMPORTANT: Make sure heat reector strip is ush against
header and spacers are on bottom side. Heat strip should
NOT be ush with leg side but should have 1" clearance on
both ends.

Right Leg
Assembly #2

Left Leg
Assembly #3

11/4"
Screws

Base #1

Flush

Figure 4 - Installing Mantel Base

IMPORTANT: Align mantel left to right on base before install­ing. Mantel legs must be ush with back of mantel base before
installation. Use a tape measure to insure accuracy.

2

www.desatech.com

123678-01A