Desa HFL200 User Manual

HFL200 SERIES BRICK LINER KIT

INSTALLATION INSTRUCTIONS

IMPORTANT: Read entire instruction sheet
before installing brick liner.

This brick liner accessory is for use in
Series 3 dual burner compact vent-free gas
fireplace systems. Do not use brick liner
accessory in any other fireplace models.

The Brick Liner Kit contains the following:

• 1 - Rear Firebrick Panel

• 2 - Side Firebrick Panels

• 2 - Retainer Brackets

• 2 - #10 Screws

Tools required:

• Phillips Screwdriver

If any of these parts are missing or damaged,
contact dealer where you purchased this kit. If
they cannot supply original replacement parts,
either contact your nearest Parts Central or call
DESA Heating Products at 1-866-672-6040 for
information.

IMPORTANT: Always handle firebrick panels
with two hands.

WARNING: Turn off, unplug,
and let fireplace cool before
installing brick liner. Only a
qualified service person should
service and repair fireplace.

1. To remove screen, lift screen up off the screws
in front of fireplace (see Figure 1).

Screws for
Mounting
Screen

Figure 1 - Removing Fireplace Screen

For more information, visit www.desatech.com

Save for future reference.

2. Carefully lift up and remove one-piece log set.

3. Install rear firebrick panel on back wall first.
Rest the bottom edge of firebrick panel on
base assembly. Stand firebrick panel straight
up against the back of fireplace (see Figure 2).

Side brick liners will hold rear firebrick

Note:

in place.

CAUTION: Always handle
firebrick panels with two hands.
Do not force firebrick panels into
place. Excessive force will break
firebrick panels.

4. Carefully slide left side firebrick panel into
fireplace. Gently press the firebrick panel back
against the side wall (see Figure 3).

5. Secure side firebrick panel to side wall of
fireplace with one retainer bracket and screw
(see Figure 4, page 3).

Note: If there is a screw in the fireplace side

walls where you are to install the retaining
bracket, remove screw.

6. Repeat steps 4 and 5 to install right side fire­brick panel.

7. Replace log set. Make sure log set is put in
the proper position. See Installing Log in the
fireplace owners manual.

8. Replace screen (see Figure 1, page 1).

Side
Wall

Side Firebrick
Panel

Rear
Firebrick
Panel

Figure 2 - Placing Rear Firebrick Panel in

2

Fireplace

www.desatech.com

Figure 3 - Placing Side Firebrick Panel in

Fireplace

116462-01A