Denver MLE-2401 Service Manual

MLE-2401

PC Monitor

Read this booklet thoroughly before using and save it for future reference

1. Product Overview

1.1 Monitor Buttons

1. M Menu Button: Press to display the OSD menu or enter sub-menus.

2. ▼ Down Button: Press to move down in the menus.

3. ▲ Up Button: Press to move up in the menus.

4. E Exit Button: Press to exit.

5. Power Button: Press to turn the monitor on/off.

6. LED Indicator: Change colors to indicate status.

1.2 Monitor Ports

7. Power Connector: Insert the power cable to supply power to the monitor.

8. Audio Output: Insert one end of the audio cable into the computer’s audio input to
receive the audio signals from your monitor.

9. VGA Connector: Insert one end of the VGA cable into the computer’s VGA output
and connect the other end to the monitor’s VGA port.

10. HDMI Connectors: Insert one end of the HDMI cable into the computer’s HDMI
output and connect the other end to the monitor’s HDMI port.

Eng- 2

2. Stand Installation

Keep the foam underneath the monitor before attaching the stand.

1. Open the package, take out the product with foam attached, and gently place them
on a desktop or table.

2. Turn the bracket to a certain angle and align it with the circular slot of the base, stick
it tightly, and then rotate clockwise to clamp the bracket into the base to complete
the installation of the base.

2.1 Make stand

aligned with the
base slot.

3. Place the top of the mounted base frame flat on the lower side slot of the rear case,
adhered and push up, then insert the base stand into the rear case.

2.2 Keep the
bracket and the
base close,
rotate the
bracket
clockwise.

2.3 Make the
bracket snap
into the base.

2.4 Lock the
screws which
contained in the
accessory bag
at the base
tightly
(PM4*12).

2.5 The
assembly is
completed.

Stand close to the back shell, and pull up.

Eng- 3