Denver IPC-1020, IPC-1030 User Guide

DENVER IPC-1020 DENVER IPC-1030

Packing list:

IP camera

CD Lan cable

Some models don’t have a separate antenna.

Note:

Mounting bracket Antenna

Installation procedure:

Start

Connect the Hardware

Install the Search Tool

Installation guide

Power Adaptor

Screws

Login the IP Camera into LAN

Wireless Settings

Login the IP Camera to the PC

Client

Access by Mobile

End

Note:

For the first time use of IP Camera, please refer to the procedures above.

Internet

IP Camera

PC

PC

Internet

WAN

Router

LAN

Router

Internet Cable

Power

IP Camera

WAN

LAN

Internet Cable

Power

Connect the camera with Internet cable to the router, and with the power cord to the mains,
like shown above.

1. Installation of the Search Tool

Next

Insert the CD and install the following software:

1. Open the File “IPC-1020 & IPC-1030”, click on “OCX setup” — “Next” — “Install” —

“Finish”

2. Open the File “Search Tool”, Copy the “Search Tool” to the desktop and launch it.

2. Login of the IP Camera into the LAN

After the hardware is connected properly, launch the search tool, and the IP address of the
camera will be displayed automatically.

Note: If the Search Tool issues the message "Subnet mask does not match, please click

Double click the camera IP address in the search tool.

In your default browser a login screen like shown below will be displayed:

Note: Both the username and password are “admin”

(Please change the account user name and password for safety later)

After entering the correct user name and password, the Login screen will be displayed.
(It supports 6 visitors watching online at the same time)

Note: If the OCX already has been installed you may login directly. If not, please install

OCX.

A. Click on “OCX” to download and Install it.
B. Refresh the webpage and login again, the camera video will be displayed as below

Live video

3. Wireless Setting

1. Click on the button to access the “Wireless” settings.

2. Search for the WIFI signals and choose the desired SSID.

3. Make sure that all parameters are the same like in your router, enter the WIFI network

key.

4. After 30 seconds click on “Check”, the notification will show you if the WIFI settings are

successful.

5. If correct, just go back to select “Apply”, then disconnect the network cable.

Note: If the camera IP Address can not be found by the search tool, please connect the

internet cable again to check the WIFI settings.