Operation Manual for DENVER DP-10 www.denver-electronics.com
FEATURES WITH DIAGRAMS |
|
|
|
(1) |
Hook Switch |
(5) |
Redial Button |
(2) |
Dialing Key |
(6) Ringer Hi/Lo Switch |
|
(3) |
Pause Button |
(7) |
Mute Button |
(4) |
R Button |
|
|
OPERATION INSTUCTIONS
Whenever the phone rings, pick it up and use it as you would with a standard telephone.
Pick up the handset and listen for a dial tone, enter the phone number you wish to dial on the keypad(2).
When you finish your conversation, return the handset to the cradle, or press the Flash button (4).
In some cases such as PABX or long distance service, PAUSE should be inserted in dialing sequence. The “PAUSE” key (3) can be inserted about 4 seconds interval with no dial output.
To be used for services offered by your telephone operating company.
If the dialing number is busy or the conversation is completed, press the “FLASH” button (4) for momentary hanging-up and picking-up the line.
Release for a new dial tone.
(Please note: this function is not available in all countries)
When the handset is lifted from the cradle and the “REDIAL” key (5) is pressed, the last number entered will be automatically redial again.
During your phone call, press MUTE button (7) if you want a private conversation not to be heard by the other party on the line. Press and hold the mute button. To continue your phone call, release the mute button.
Set Ringer Switch to “H” ( High ) or “L” ( Low ) position to adjust the volume of the ringer.
ALL RIGHTS RESERVED
COPY RIGHT DENVER ELECTRONICS A/S
Hereby, INTER SALES A/S, declares that this DENVER DP-10 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.