Denver CRP-210 User Manual

Document1 12/16/02 7:23 PM Page 1

1

14

5

6

17
18

8

1. AC POWER CORD

2. FM ANTENNA WIRE

4

2

12
11

10
13

15
16

3

7

9

3. SNOOZE BUTTON

4. BATTERY COMPARTMENT

5. CLOCK SETTING SWITCH (RUN / ALM / TIME)

6. POWER SWITCH (ON / AUTO / OFF)

7. LED DISPLAY

8. ROTARY SET DIAL

9. SLEEP BUTTON

10. TUNING CONTROL KNOB

11. AM / FM BAND SELECTION SWITCH

12. VOLUME / BUZZ KNOB

13. PROJECTION

14. PROJECTION ON / OFF

15. MINUTE BUTTON FOR PROJECTION

16. HOUR BUTTON FOR PROJECTION

17. FOCUS FOR BRIGHTNESS ADJUSTMENT

18. TIME SET BUTTON FOR PROJECTION

ENGLISH

Document1 12/16/02 7:23 PM Page 2

POWER CONNECTION

Plug the AC POWER CORD (1) to the household outlet. Make sure the voltage
is correct for safety purpose and prevent plausible damages to the set.
Connect one 9 volt battery (not included) to the battery terminals in the
BATTERY COMPARTMENT (4). It maintains the clock continue memory
whenever the AC power is interrupted.
Please note : The display will not exhibit time during power failure but

RADIO OPERATION

Set the POWER SWITCH (6) to "ON" position.

1.
Set the AM/FM BAND SELECTION SWITCH (11) to desired waveband.

2.
Tune to the desired station with TUNING CONTROL (10).

3.
Adjust the volume level with VOLUME CONTROL (12).

4.
To obtain better FM reception, lay out the FM ANTENNA WIRE (2) to it's

5.
full extent; or for built-in FM antenna version, uncoil and fully extend AC
POWER CORD (1).
The radio can be switched off by setting POWER SWITCH (6) to the "OFF"

6.
position.

SETTING THE CLOCK TO THE TIME OF DAY

Set the CLOCK SETTING SWITCH (5) to the time set position, and then
rotate the dial to the left (min) or right (hour) hand side to set the current time.
Once the time is set, set the CLOCK SETTING SWITCH (5) to "RUN"
position to stop the 2 flashing dots.

SETTING THE ALARM TIME

Set the CLOCK SETTING SWITCH (5) to the alarm set position, and
then rotate the dial to the left (min) or right (hour) hand side to set the
alarm time. Once the time is set, set the CLOCK SETTING SWITCH (5)
to " RUN" position to stop the 2 flashing dots.

NOTE:

Do not rotate the dial too quickly when you are setting the time, otherwise
the clock radio cannot keep up with your speed and set your desired time
normally.

ALARM RADIO

Set the POWER SWITCH (6) to the AUTO position

RADIO:

BUZZER:

the clock will keep correct time.

Wake to radio. The radio must be tuned on a station and set the
volume to the desired level. The radio will switch on at the
selected alarm time.
Wake to Buzzer. Slide the VOLUME BUZZ KNOB (12) to the
BUZZ position until you hear a "CLICK" sound. The alarm will
switch on at the selected time.