Delvcam DELVSALPR1 User Manual

DDEELLVV--SSAALLPPRR11

UUnniivveerrssaall VViiddeeoo LLooooppiinngg AAddaapptteerr

Operation Manual

DDEELLVV--SSAALLPPRR11

The DELV-SALPR1 provides looping/bridging video for ANY video monitor with a built-in (onboard)
75 ohm termination. The product allows the use of standard looping video to feed a signal to
several in-line monitors. Velcro is provided for you to attach the module to the rear of the
monitor. Make certain not to block any ventilation slots on the monitor.

TThhee pp rroo dduucctt iiss ddee ssiiggnneedd ff oorr ttww oo aapppplliiccaa ttiioonn ss::

PPRROOVVIIDDIINNGG IINNPPUUTT 7755 OOHHMM LLOOOOPPIINNGG FFOORR AA MMOONN IITTOORR WWIITTHH BBUUIILLTT--IINN TTEERRMM IINN AATTIIOONN

This application is designed for those monitors or TV/Monitors which provide for a Composite
Video Input to a self terminating input (typically RCA). You cannot LOOP the input video from this
type monitor to another monitor since this will cause DOUBLE TERMINATION and a degrading of
the video signal. The DELV-SALPR1 will accept the video signal and provide a signal to feed the
monitor input and another LOOP signal to continue to a second monitor or compatible video
device. The second device will also need to be terminated. A 75 ohm terminator is
provided in the event that the LOOP OUT signal is NOT used. Power for the product is provided
by the included 12V DC adapter. Any compatible 12V DC @ 100mA can be used in the event that
power is provided by your facility.

UUSSIINNGG TTHHEE DD EELLVV--SS AALLPPRR11 AASS AA VVIIDDEEOO DD IIRREECCTTIIOONNAALL TTAAPP OORR VVIIDDEEOO BBRRIIDD GGEE

This application is very handy when you need to simply split a composite video signal into two
equal 75 ohm signals. Simply feed the composite signal to the connector marked: VIDEO INPUT
and then the LOOP OUT to any other compatible 75 ohm device INPUT. The VIDEO OUT
connector will provide and identical 75 ohm video signal to feed to another device.

Universal Video Looping Adapter

NOTE - POWER SWITCH TOGGLE: This switch is provided in the event that 12 Volt DC battery
power is used. In this case please be certain to set the switch to OFF when you are not using the
product. This will save battery power. This feature also disables the VIDEO OUT tap but
not the LOOP OUT.