Page 1
Operation Manual
DELV-RM2
Rackmount Kit for DELV-PRO56 5.6"
High Resolution Monitor
Page 2
DELV-RM2
Rackmount System
I. Setup Instructions
5.6" High Resolution Monitor
The DELV-RM2 is designed to mount 2 DELVCAM DELV-PRO56 5.6” moni-
tors. If you are rackmounting just one monitor, then leave the installed filler
panel in place as shipped. The monitor can be installed in 2 different display
options. The second option (hood mounting) requires the optional DELV-RC
Roll Cage hood.
II. Flush Mounting
Using the large thumbscrew provided,
mount the monitor as pictured in Figure-
1A & Figure-1B. The slotted mounting
tabs on the rackmount will be facing the
rear. Slide the monitor until it’s flush with
the rack opening and then tighten the
thumbscrew (Figure-1C).
Figure-1A
(front view)
If the monitor is not being mounted in a
console or rack, the rear mounting tabs on
the rackmount may be used to support the
setup.
NOTE: IN THIS CONFIGURATION, YOUWILL
NOT BE ABLE TO ACCESS THE MONITOR
ADJUSTMENTS ONCE THE RACK IS
INSTALLED IN A 19” STANDARD RACK
CONSOLE.
Figure-1B
(rear view)
Figure-1C
(rear view)
Page 3
DELV-RM2
Rackmount System
III. Hood Mounting
In this configuration the slotted mounting tabs will be facing front as shown
Figure-2A.
Place the monitor in the DELV-RC hood
(optional) as shown in Figure-2B. Next,
use the thumbscrew screw to attach the
hood/monitor assembly to the slotted
rackmount tab as shown in Figure-2A.
NOTE: IN THIS CONFIGURATION, ALL
CONTROLS ARE ACCESSIBLE AFTER THE
UNIT IS RACKMOUNTED.
5.6" High Resolution Monitor
Figure-2A
(front view)
Figure-2B
(front view)
PLEASE FOLLOW ALL OF THE SAFETY INSTRUCTIONS PROVIDED
WITH THE DELVCAM MONITOR WHEN USING THIS SYSTEM.
© 2003 Tower Products, Inc. Saugerties, New York.
Page 4
812 Kings Highway
Saugerties, NY 12477
Tel 845-246-0428
Fax 845-246-0626
Loading...