Delta Electronics VFD-PU06 User Manual

2007-07-19

VFD-PU06

Digital Keypad Instruction Sheet

X Description of the Digital keypad VFD-PU06

Frequency Command

Status indicator

Output Frequency

Status indicator

User Defined Units

Status indicator

JOG

By pressing JOG key, Jog frequency operation.

UP and DO WN Key

Set the parameter number and changes the numerical data, such as Master Frequency.

Left Key

Move cursor to the left.

FWD/REV Key

Select FWD/REV operation.

F H U

JOG

RUN

VFD-PU06

EXT P U

STOP

RESET

Y Explanation of Display Message

5011615002-U6E2

LED Display

Indicates frequency, voltage, current, user defined units, read, and save, etc.

Model Number

Status Display

Display the driver's current status.

MODE

Change between different display mode.

Right key

Move the cursor to the right

STOP/RESET

Stops AC drive operation and reset the drive after fault occurred.

RUN Key

Start AC drive operation.

Display Message Descriptions

The AC motor drive Master Frequency Command.

The Actual Operation Frequency present at terminals U, V, and W.

The custom unit (u)

The output current present at terminals U, V, and W.

Press

sec or until it’s flashing, read the parameters of AC drive to the digital keypad

PU06. It can read 4 groups of parameters to PU06. (read 0 - read 3)

Press

or until it’s flashing, then write the parameters from the digital keypad PU06 to

AC drive. If it has saved, it will show the type of AC motor drive.

The specified parameter setting.

to change the mode to READ. Press PROG/DATA for about 2

to change the mode to SAVE. Press PROG/DATA for about 2 sec

The actual value stored in the specified parameter.

Display Message Descriptions

External Fault

“End” displays for approximately 1 second if the entered input data have been

accepted. After a parameter value has been set, the new value is automatically

stored in memory. To modify an entry, use the

or keys.

“Err” displays if the input is invalid.

Communication Error. Please check the AC motor drive user manual (Chapter

5, Group 9 Communication Parameter) for more details.

Z Operation Flow Chart

VFD-PU06 Operation Flow Chart

-ERR-

Program Error

XX-XX

XXXXX

-END-

Program Successful

Press UP key to select SAVE or READ. Press PROG/DATA for about 2 seconds or until it is flashing, then save parameters AC drive from AC drive to PU06

from PU06 to

or read parameters