Delphi Roady 2 SA10109-11P1, Raady2 Quick Manual

Personal Audio System

Quick Guide

For Use With Roady2™Satellite Radio Receiver

Delphi Corporation
1441 West Long Lake Road • Troy, Michigan 48098-5090 U.S.A.
Customer Service: [1] 877.GO DELPHI

www.delphi.com
www.shopdelphi.com

The Roady2 name, XM name, and related logos are trademarks
of XM Satellite Radio Inc.

©2004 Delphi Corporation. All rights reserved.
DPSS-04-E-069

Tuning XM Channels

Switch to XM mode, then use
your Roady2 controls as usual.

Tuning FM channels

Switch to FM mode, then move
the joystick to change channels.
A short tap and release will
tune to the next station. Hold in
either side for one second and
release it to seek until an FM
station is found. Tap the joystick
anywhere to stop.

Volume

It’s best to change the volume
using the joystick controls, but
you can also use the volume
control on your headset, or on
the Roady2 unit itself.

Using Your Roady2 Personal Audio System

FM button

Channel control

Volume control

Step 1:

Push down the latches on
both sides.

Step 2:

Slide the tray out.

Setting up Your Roady2

™

Personal Audio System

Note: Before using your Roady2 Personal

Audio System for the first time, it is
recommended that you fully charge
the battery. See your
Roady2 Personal
Audio System

User Guide

for more
information.

Caution: Turn down the volume before
using headset to avoid ear damage.

Important Things
to Know

Display

The Roady2 Personal Audio
System display shows the
mode (FM or XM), FM
station, battery charge indicator,
and volume. (XM channels
appear on your Roady2 display.)

Backlight

Any time you adjust the controls
or change modes, the blue
LED backlight comes on so
you can easily read the display.

Roady2 setup

See page 5 of your Roady2

User Guide for important setup

information.

Headset

Your Roady2 Personal Audio
System headset not only
produces great sound, it
contains a built-in antenna.
Keep th e antenna in line of
sight with the satellite for best
reception. You can adjust the
volume with the control on
the right side.

Battery pack

To recharge the battery, plug
the AC adaptor into the unit
with the battery in place. The
Lithium Ion battery will fully
charge in about two hours
when the unit is turned off, but
you can charge it while using it.
The indicators at the upper left
part of the display indicate the
state of the battery.

Mode switch

Step 3:

Gently place your Roady2 into
the docking station and slide the
tray back in until latches click.

Step 4:

Plug in your headset.

Step 5:

Slide the mode switch to XM or FM.

Important: For Roady2 operating instructions,
consult the Roady2

User Manual that came

with your Roady2.

Step 6:

Remove your Roady2 by pushing down
the latches on both sides and sliding
the tray outward.