Delonghi TRSW 1020 T Instructions Manual
instructions
STRETTO
Please retain these instructions for future reference
Stretto
2
Thank you for choosing this De’Longhi heater. To get the
very best out of your new heater it is advisable to read
these instructions before using it.This will ensure that you
gain optimum results and use the appliance safely.
General instructions
1. Remove the heater from the packaging.
2. Turn the heater upside down and rest on the polystyrene.
3. Check that neither the heater nor the power cable has been
damaged in any way during transportation.
4. Do not operate the heater if damaged.
5. Your heater is suitable for either freestanding or wall mounting
usage.
Make sure that no pieces of polystyrene or other packaging material have been left between the elements of the appliance.
It may be necessary to use a vacuum cleaner to help elimate the
small pieces.
Fitting the castors
Remove the castors, wheels and assemblies from the polystyrene
packaging.
In the unlikely event that there are any parts missing please contact
our customer services department on 0845 600 6845 who will
send you the part by return.
Insert the castors into the pins of the feet and push them all the
way in until a click can be heard (fig1) Make sure that they are in
tightly by pulling the wheels gently. Attach the castor assembly into
the base of the control panel by inserting the guiding ridges
between the control panel and the first element and between the
end panel and the last element; insert the location lug into his
housing and lock the castor assembly to the product by inserting
the eye screw and screwing it in tightly (fig1). Finally turn the
heater over to its upright position, ensuring you do not damage
the wheels.
fig.1
Stretto
3
Installation wall-mounting
The wall mounting kit should contain:
2 x Upper brackets (A)
1 x Lower brackets (B)
1. Select position for siting the heater ensuring that:
a. It is not located directly below a power socket outlet.
b. The plug and power outlet can be easily reached after
installation.
c. No electric cables or other tubes could be damaged.
d. Keep away from curtains or inflammable materials. Also
note the minimum distances indicated in the figure 2.
Important
Before drilling into any wall ensure no electrical cables are present
in the area.
2. Following carefully the dimensions as indicated below (the distance depends on which model you have purchased) mark distance “D” on your wall.
3. Line up the centre of the holes of the brackets “A” with the
marked line (indicated in fig.3/4 as a dashed line) ensuring that the
2 brackets are level, mark the holes to be drilled.
4. For solid brick block walls, use a 6 mm masonry drill and drill the
marked holes and then insert wall plugs to suit.
(For plasterboard we suggest, locating the studding and using No
6 woodscrews directly into the wood, or special plasterboard fixings. For other wall types please seek specialist advice).
Model
1 Kw
1,5 Kw
2 Kw
2,5 Kw
Distance
D
D
D
D
mm
140 mm
210 mm
280 mm
385 mm
D
A
A
=
=
B
fig.3
250mm
Fig.2
Minimum distances
from surrounding
walls/ furnishings
fig.4
D
D
150mm
150mm
150mm
Loading...