6
Read this instruction booklet carefully before using the appliance.
This is the only way to ensure the best results and maximum safety for the user.
Keep this booklet with care for future reference.
1. After having removed the packaging, make sure that the appliance is complete. If in doubt, do not use the appliance and only contact qualified personnel or an authorised service centre.
2. The appliance must be used exclusively for the purposes it has been
expressly designed for, that is, to dry bath towels and garments. All other
uses are considered incorrect and thus dangerous. Take care when using
the appliance with particularly delicate garments (wool, silk, nylon, etc).
The manufacturer cannot be held responsible for any damage caused by
improper, erroneous and unreasonable use.
NOTE: This appliance is designed exclusively for drying fabrics washed in water.
3. The use of any electrical appliance requires the observance of a number of
fundamental rules, specifically:
- DO NOT TOUCH the appliance with wet or damp hands or feet.
- DO NOT LEAVE the appliance exposed to the elements.
- DO NOT ALLOW the appliance to be used by children or unfit persons
without supervision.
- DO NOT unplug the appliance from the outlet by PULLING on the cord.
4. If the plug fitted to the appliance does not match the power outlet, have the
outlet replaced with one that is suitable by qualified personnel.
5. To dispose of the appliance definitively, after having unplugged it from the
power outlet, it should be rendered unusable by cutting the power cord.
6. The electrical feed cord must be replaced only by officially authorised personnel.
Do not use water directly on the appliance or in its immediate vicinity.
DO NOT IMMERSE IN WATER.
DESCRIPTION OF THE APPLIANCE
A= Swing arm
B= ON/OFF switch with signal light
C= Towel warmer
D= Towel warmer/upright fastening screws
E= Base with wheels
F= Upright/Base screws
G= Upright
H= Knob
INSTALLATION
Insert the base with wheels E onto the upright G, as shown in figure 1, then fasten
the parts together using the three screws (F).
Insert the towel warmer C on the upright assembly G/E, making sure that the die
X on the upright is correctly fitted to the corresponding guide Y (see Figure 2),
after inserting the heated towel rail into the stand (G), fix it with the screw (D) supplied,
pushing the end of the plastic part (I) downwards to align it with the holes (fig3).
The position of the appliance must not allow a person to touch the controls
from inside the bathtub or in the shower. Keep the appliance at least 50 cm
from flammable objects and substances. The power outlet used for this
appliance must be outside of the areas in which the presence of water may
represent a source of danger. (Fig. 5)
GENERAL WARNINGS
GB