De'Longhi S.p.A.
via Seitz, 47
31100 Treviso Italia
FRULLATORE
BLENDER
MIXER
MIXER
ELEKTRISCHE MIXER
BATIDORA DE VASO
LIQUIDIFICADOR
ª¶§∂¡∆∂ƒ
MIKSER
MIXER
MIKSER
TEHOSEKOITIN
MALAKSER
TURMIXGÉP
MIXÉR
ååààääëëÖÖêê
Istruzioni per l’uso
Instructions for use
Mode d’emploi
Gebrauchsanweisung
Gebruiksaanwijzingen
Instrucciones para el uso
Instruções de utilização
√‰ËÁ›Â˜ ¯Ú‹Û˘
Instruktioner
Bruksanvisning
Bruksveiledning
Käyttöohje
Instrukcja obs∏ugi
Használati utasítás
Návod k pouÏití
аМТЪЫНˆЛЛ ФУ ˝НТФОЫ‡Ъ‡ˆЛЛ
10
ELECTRICAL CONNECTION (U.K. ONLY)
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should
be cut off from the mains lead, and on appropriate plug fitted, as below. warning: Very carefully dispose of the cut off
plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock
hazard. With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is
a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS
1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained
from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the
plug.
B) If your appliance is not fitted with a plug, please follow the instructins provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance
with the following code:
Green and yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol
or coloured green or green and yellow.
The blue wire must be connected to the terminal marked
with the letter N or coloured black.
The brown wire must be connected to the terminal marked
with the letter L or coloured red.