Delonghi HCX9120E Instruction manuals

IMPORTANT WARNINGS
Safety warnings

Important!

- This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way
and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not
be made by children without supervision.

- Children of less than 3 years should
be kept away unless continuously
supervised.

- Children aged from 3 years and less
than 8 years shall only switch on/
o the appliance provided that it has
been placed or installed in its intended
normal operating position and they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children aged from 3 years
and less than 8 years shall not plug in,
regulate and clean the appliance or
perform user maintenance. CAUTION —
Some parts of this product can become
very hot and cause burns. Particular
attention has to be given where children
and vulnerable people are present.

- WARNING: In order to avoid
overheating, never under
any circumstances cover the
appliances during operation, as this
would lead to dangerous overheating.

- The appliance must not be located
immediately below a xed socket-outlet.

- When the heater is used with feet do

not use in the vicinity of bathtubs, wash
basins, showers, sinks and swimming
pools.

- If you intend to x your appliance to the
wall, make sure that the switch or other
control devices are not within reach of
persons in the bath or shower.

- If the power cable has been damaged, it
must be replaced by the manufacturer
or the technical service centre or by a
qualied person so as to avoid all risks.

- ATTENTION: in order to avoid any danger
caused by an accidental resetting of the
safety system, this appliance must not
be powered through an external timer.

-

Do not use the appliance in small rooms

when they are occupied by persons that
are not capable of leaving the room,
unless constant supervision is provided.

Please note:

- Never use the heater to dry laundry.

- Never place the power cable on top of the heater while it is
hot.

- We recommend that you not place the heater in a draught,
because strong draughts of air may adversely aect the
equipment’s operational eciency.

- Only use the heater in an upright position.

- The heater must be positioned at least 80cm from furniture
or other objects.

- The rst time you use the appliance, operate it of at least 15
minutes with the thermostat at maximum to eliminate the
“new” smell. A little smoke due to the protective substances
applied to the heating element before transport may be
given o.

- Do not position the appliance on long hair carpets, in order
to avoid obstruction to the air intake grille located under it.

- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.

- Position the appliance so that the plug and the outlet can
be easily reached even after installation.

- Do not use the appliance in rooms less than 4m2 in
area.

- A tip over safety device turns the appliance o if it falls
over or is positioned inappropriately in such a way as to
jeopardise safety. The appliance emits a beep and a dot

8

ashes on the display. The appliance resumes operation
a few seconds after being placed in an upright position
again.

See troubleshooting session. See the following

paragraph: "troubleshooting".

- The appliance is tted with a safety device which will
switch the appliance o in case of accidental overheating.
To reset, disconnect the plug from the power socket for a
few minutes, remove the cause of overheating then plug
the appliance in again. If this abnormal situation happens
several times, please contact the customer service.

Danger of burns!!

- The use of an extension lead is not recommended, as
overheating of the extension lead may occur during the
operation of the heater.

DESCRIPTION

A Power indicator light
B ON/STAND-BY button
C +/- adjustment buttons
D MODE button (selects the operating mode)
E “ECO plus” button
F Timer button

General instructions

Remove the heater from the packaging. Check that neither the
heater nor the power cable has been damaged during transport.
Do not operate the heater if damaged. Remove all publicity
material present on the appliance. The appliance is suitable for
free-standing or wall-mounted usage. Do not assemble the feet
if wall-mounted.

The appliance complies with the following EC directives:

- Low Voltage Directive 2006/95/EC and subsequent
amendments;

- EEC Directive 2004/108 on electromagnetic compatibility
(EMC) and subsequent amendments;

Disposing of the appliance

In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with household
waste, but taken to an authorised waste separation and
recycling centre.

INTRODUCTION

Thank you for choosing a De’Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.

Symbols used in these instructions

Important warnings are identied by the symbols below.
It is important to respect the warnings. Failure to respect the
warnings could lead to electric shock, serious injury, burns, re
or damage to the appliance.

Important!

Failure to observe the warning could result in injury or damage
to the appliance.

Danger of burns!!

Failure to observe the warning could result in burns or scalds.

Please note:

This symbol indicates recommendations and important
information for the user.

Electrical connection

- Before connecting the appliance to the current outlet,
check that the voltage indicated on the appliance rating
plate is the same as your electric plant and that it can stand
the power consumption (Watt) indicated by the labelling.

- If more than one appliance is used at once, it is important to
ensure that the electric plant is able to support the power
required.

Mounting the feet

Turn the appliance upside down on a rug or soft surface in order
to prevent damaging the paint nish.
Fix the feet to the appliance with the nr. 4 screws B supplied

(see g. 1), 2 screws for each foot.

Wall-Mounting Installation

The wall mounting kit contains:
4 metal brackets (A)

2 screws 4,8x13 PH (B)

4 screws 4,5x25 PH (C)

4 plastic anchors 6x30 (D)

Required tools for assembly and estimated assembly
time

Screwdriver PH 2 x 100 (Phillips type)
Estimated assembly time: 30 minutes

Before installing the unit , make sure of the following:

a. The appliance must not be located directly beneath

a current outlet.

b. The plug and outlet must be easy to reach after

installation.

9