Installation and operation
(1).Before washing
1. Install the machine on a firm and flat floor (allow most obli que angle to 2”) if the machine is not
leveled, the machine may make a big vibration and noise.
2. Suspend the drain hose on the hose hook at the right side of the machine; lay the drain hose down
when you want to discharge water.
3. Set the water supply hose connect one rubber packing of the water supply hose to the end of the
tap; connect the other one to the water supply port on the machine.
4. Plug the power cord into the socket, in case of the machine with two conductor power cords, be
sure to connect the ground wire to a proper ground, never connect the earth wire to a gas pipe, a tap
water pipe, a phone wire and lighting rod.
5. Check the laundry according to the indication of the items, confirm whether it can be washed or
not, below are shown those which cannot be washed.
● Blanket
● Clothes with oil, solvents and chemicals
● Cloth shoes etc.
(2).Washing guide
1. Put the laundry into the wash tub, turn the tap, let water into the tub according to the amount of
clothing to be washed(the marks H.M.L. in the inner tub are high, medial and low water level).
2. Add the proper amount of detergent, if the amount of detergent is too much, the laundry can’t be
rinsed sufficiently, so please add the proper amount of detergent.
3. Turn the “WASH TIMER” knob to the desired wash time clock wise and the washing action will
begin. Set the washing time according to how the laundry soiled or its amount. Normally, the timer for
low soiled laundry is around 8 minutes and more than 12 minutes for the extremely soiled laundry.
4. After washing is completed, drain the water by laying down the drain hose, twist the laundry and
prepare for rinsing.
5. The washing machine have vents, blocked vents are not carpet.