F5 30” DEEP PASS THROUGH SELF-CONTAINED DROP IN REFRIGERATED DISPLAY
__________________________
____________________________
_________________________
30” Deep Pass Through Self-Contained Refrigerated Display Cases
gauge stainless steel. Exterior display section top
to be 22-gauge galvanized metal. Interior sides
are made of .095” thick ABS plastic with molded
shelf supports. The interior bottom is constructed
with stainless steel for long lasting durability.
polyurethane foam between the interior and exte-
rior. Four adjustable epoxy coated wire shelves
are provided for the display section. An on/off
switch for the display section light(s) is located at
the right end of the front facing, above the display
full-length top mounted coil with multiple fans
circulating the air throughout the cabinet utilizing
a thermostatic control. An ABS plastic drip pan is
placed below the coil with a clear drain hose for running
the condensation to the lower base mechanical section.
and removable self-closing .50” thick argon fi lled,
low-e glass doors with a warm edge spacer. The vertical
outsides of each door tuck into an extruded channel
running vertically up each side. Front and rear nosing
to be 20-gauge stainless steel.
Self-contained models have a pre-wired condensing
unit housed in a 16-gauge cage hanging form the units
exterior bottom. Cage also is supplied with an 8’ cord
and plug and electrical junction box. Electrical connec-
play cabinet blower coil assembly shall have a coated
evaporator coil and fans. Interior refrigerated base
cabinet and display section to maintain 36 to 40
degree temperatures at 100-degree ambient room
thick argon fi lled, low-e glass doors with a warm
30” Deep Self-Contained Drop In
30” Deep Self-Contained Drop In
• Display exterior sides are made of 18-gauge stainless
• ABS plastic interior sides with molded shelf supports
• (4) adjustable epoxy coated wire shelves
• On/off switch for the display section light(s)
• Top mount coil with multiple fans circulating the air
• Display section runs off a thermostatic control
• Sliding and removable self-closing .50” thick argon
filled, low-E, warm edge insert, thermopane glass doors
with left and right vertical gasket
• High density polyurethane foam throughout unit
• Single service display section with mirrored back
• Environmentally friendly HFC-404A refrigerant
48” shelf (48” long units only)
72” shelf (72” long units only)
Mirrored interior on pass-through doors (48”)
Mirrored interior on pass-through doors (72”)
220 volt/50 cycle - inclusion of this option will
PLAN VIEW F5PC48D PLAN VIEW F5PC72D
CUTOUT DIMENSIONS:
• 48" LONG MODELS
23.62" x 18.62" (60.0cm x 47.3cm)
• 72" LONG MODELS
32.62" x 18.62" (82.9cm x 47.3cm)
J
MECHANICAL ACCESS
PLAN VIEW ALL MODELS
front to rear on 48” models and right to left on 72”
models, using the supplied louvered panels. Louver
cut-out dimensions are 23.5” by 12” (59.7cm x
30.5cm). Unobstructed airfl ow must be maintained
to insure unit performance and maintain warranty.
MODEL SHELF AREA STORAGE SYS. CAP CABINET LOAD VOLTS/HERTZ NEMA SHIPPING
NUMBER SQ. FT. CU. FT. H.P. BTU/HOUR BTU/HOUR PHASE AMPS PLUG WEIGHT
28.2 19.0 1/2 3160 1945 115/60/1 12.0 5-15P 609/276
44.0 29.4 3/4 5758 2884 115/60/1 16.0 5-20P 815/370
Mechanical Data–Standard Unit
ELEVATION VIEW F5PC48D
ELEVATION VIEW F5PC72D