Delfield 7048-M User Manual

Show ’N’ Sell self-contained refrigerated display cases

Short form specifications

Exterior top and ends shall be finished with 22-gauge stainless steel. Exterior front shall be finished with stainless steel and plastic laminate trim. Interior ends shall be ABS plastic. Interior bottom shall be 22-gauge stainless steel. Cabinet shall be insulated with foamed-in-place polyurethane.

Interior shall have (2) 15" (38.1 cm) deep removable epoxy-coated wire shelves. Cabinet shall have (2) 36" (91.4 cm) long fluorescent light fixtures.

Refrigeration system shall use HFC-404A refrigerant, and maintain 36°F (2°C) to 40°F (4°C) interior cabinet temperature at 100°F (38°C) ambient room temperature.

Electrical connections shall be 115 volt, 60 Her tz, single phase. Unit shall be wired with a 3-wire, grounded, maximum 8' (2.4 m) cord and plug.

The following applies to 7000-M (single service mirrorback) models only:

(2) 0.5" (1.3 cm) thick, bottom-mounted thermopane glass doors shall be provided in the front of the equipment. Doors shall be sliding, self-closing and removable for cleaning. Exterior back shall be 22-gauge aluminum. Interior back of cabinet shall have a 0.25" (0.6 cm) thick mirror mounted vertically.

The following applies to 7000-S (single service seethrough) models only:

(2) 0.5" (1.3 cm) thick, bottom-mounted thermopane glass doors shall be provided in the front of the equipemnt. Doors shall be sliding, self-closing and removable for cleaning. Exterior back to be finished with stainless steel and plastic laminate trim. Interior back of cabinet shall have a 0.5" (1.3 cm) thick thermopane glass panel.

The following applies to 7000-P (double service passthrough) models only:

(4) 0.5" (1.3 cm) thick, bottom-mounted thermopane glass doors shall be provided, (2) each in the front and back of the equipment. Doors shall be sliding, self-closing and removable for cleaning.

Optional accessories & modifications

*220 volt, 50 Hertz electrical system

Wall-mounting kit

Sliding door lock

(4) 6" (15.2 cm) high stainless steel legs

Extra epoxy-coated wire shelf

*Inclusion of this option will alter

the electrical specifications of the unit.

PROJECT

ITEM #

QUANTITY DATE

APPROVAL

7000

Model 7048-M

The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com

7000

MODEL

NUMBER DESCRIPTION

SHELVES CAPACITY

SHIP

WEIGHT

HORSEPOWER

VOLTS/ HERTZ/

PHASE AMPS

NEMA PLUG

7048-M

Single service,

mirror back

12.5 ft2¤

1.16 m2¤

7.8 ft

0.22 m

284 lbs 129 kg

1/4 115/60/1 9.0 5-15P

7048-P

Double service,

pass through

12.5 ft2¤

1.16 m2¤

7.8 ft

0.22 m

292 lbs 132 kg

1/4 115/60/1

9.0

5-15P

7048-S

Single service,

glass back

12.5 ft2¤

1.16 m2¤

7.8 ft

0.22 m

282 lbs 128 kg

1/4 115/60/1

9.0

5-15P

Show ’N’ Sell self-contained refrigerated display cases

24.37"

61.9 cm

25.12"

63.8cm

48.37"

122.9 cm

PLAN VIEW ALL 7000 MODELS

Entry Side ( Serving View)

Inside dimension (horizontal):

37.62"/95.6cm

ELEVATION VIEW ALL 7000 MODELS

Entry Access

Height shown is without optional legs. Add 6" (15.2 cm) if equipped with legs.

24.37"

61.9cm

18.75"

47.6cm

25.0"/6.4 cm

15.00" 38.1cm

18.50" 47.0cm

RIGHT END VIEW

7000-M and 7000-S MODELS

24.37"

61.9cm

18.75"

47.6cm

25.0"/6.4 cm

15.00" 38.1cm

18.50" 47.0cm

RIGHT END VIEW

7000-P MODELS

The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com

12.00"

30.5cm

EXIT LOCATION FOR CORD

ALL 7000 MODELS

2.75"

7.0cm

Equipment must be installed in a level area away from any source of intense heat, including ranges and ovens. Proper air flow must be provided to the machine compartment. Do not install this equipment in a location which closes off both the side and rear ventilation of the machine compartment. Either the side or front ventilation must be left open with a minimum clearance of 6" (15.2 cm).

DS7000 02/02