Defy Appliances 735 MF, 731 MF User Manual

Owner’s Manual

MULTIFUNCTION THERMOFAN STOVES

731 MF 735 MF

CONTENTS

2 Introduction 2 Unpacking 2 Installation 2 Electrical Installation 3 The Control Panel 3 Automatic Oven Timer / Clock 6 Warmer Drawer 7 Multifunction Oven (6 functions) 10 Solid Plates (model 731MF) 11 Ceran Smooth Top (model

735MF) 12 Maintenance 13 Safety Advice 13 Owner’s Responsibility 14 Problem Check 14 Service

www.defy.co.za

INTRODUCTION

Congratulations on the purchase of this quality product. We trust that you will enjoy many years of trouble free use. Please read these instructions carefully before using the stove. This manual will provide you with information on how to operate and care for your product in order that you gain the maximum benefit from it.

UNPACKING

• Please ensure that packaging material is disposed of in a responsible manner.

• Plastic bags should be cut up to prevent children playing with them and

accidentally suffocating.

• Remove all packing from the oven cavity and position the accessories.

• If the appliance is damaged in any way, do not use it. Report the damage to your

dealer, who will take the necessary corrective action.

INSTALLATION

• Levelling feet are provided to assist you in positioning your stove, so that it will stand firm and level. To adjust the level, turn the relevant foot to either raise or lower the stove.

• Surfaces immediately adjacent to the oven should be able to withstand temperatures of up to 100°C without delaminating or discolouring.

ELECTRICAL INSTALLATION

“This appliance must be earthed and the manufacturer and the seller do not

accept responsibility for any damage due to incorrect installation or electrical

connection.”

• This appliance should not be connected through an earth leakage system. Refer to

S.A.B.S. 0147.

Connection to the power supply This appliance has a ‘Y’ type supply cord connection and must be installed by a licensed electrician, who will ensure that the oven is correctly connected and safely earthed. The rated current is printed on the serial number label attached to the stove upper back panel.

The appliance must be connected the mains through an All pole isolating switch which has a minimum clearance between the contacts of 3 mm. in All poles. A means for disconnection must be provided in the fixed wiring.

CONTROL PANEL (731MF and 735MF)

WARMING DRAWER

12:45

UTOMATIC

DIGITAL

CLOCK AND

TIMER

OVEN

THERMOSTAT

STOP

LEFT

FRONT

MULTI FUNCTION SELECTOR

Fan only (defrost) Conventional cooking

Fan assisted conventional cooking

Thermofan cooking Turbo grill

Conventional grill

LEFT

BACK

PLATE CONTROLS AND PILOT LIGHTS

AUTOMATIC OVEN TIMER / CLOCK

RIGHT BACK

RIGHT FRONT

NOTE

variable grill option is catered For by selecting Turbo Grill and Then setting the oven thermostat to the desired grill temperature

BUTTON FUNCTIONS

= MINUTE MINDER

= COOKING PERIOD

= STOP TIME

= MANUAL CONTROL

= SUBTRACT

= ADD

Setting the time of day

• When the power is first connected (or after a power failure), the clock display will flash 00.00

• To set the clock, press buttons 1 and 2 and hold them down.

• Press button 5 or 6 until the correct time of day is displayed.

• Release the buttons. The clock is now set.

• Please note that the clock has a 24 hour display.

• For example 3.00 PM will be displayed as 15.00.

Minute minder

• Suppose that you wish to time the boiling of a 5 minute egg.

• First boil the water

• Press and hold button 1. The display will show 00.00

• Press button 6 until the display shows 00.05

• Release the buttons and place the egg in the boiling water. The display will again

show the time of day.

• After 5 minutes the timer will emit an electronic tone which lasts for about one minute (2 beeps every 2 seconds). To cancel the tone, press any of the buttons.

Note:

• During the operation of the minute the remaining time may be displayed pushing button 1

• The minute minder can be used simultaneously and independent of any automatic control program

• The display will always revert to the time of day after any program has been set.

Switching the oven on and off automatically (Autobake)

Autobake is intended for dishes such as roasts and casseroles. These are not affected by a waiting period in a cold oven.

• Prepare your meal and place it in the oven.

• Set the cooking period required by pressing buttons 2 and 6 until the desired

period is displayed.

• Set the stop time by pushing buttons 3 and 6 until the desired stop time is displayed.

• Release the buttons and the clock will again display the time of day.

• The word AUTO will light up on the clock display.

• Set the multi function selector where applicable to the desired function.

• Now set the relevant oven thermostat the desired temperature setting.

The automatic control will automatically switch the oven on and the symbol will light up in the clock display. Cooking will commence at the selected temperature and for the selected cooking period. The oven will automatically switch off at the selected stop time and emit an electronic tone for about one minute ( 4 beeps every 2 seconds ).To cancel the tone, press any of the buttons.

• The word AUTO will flash until button 4 is pressed and manual control is restored.

• Return the multi function selector to the OFF position.

• The oven thermostat must be turned to the OFF position in an anticlockwise

direction.

321

Example:

Suppose the time of day is now 13h00. The food needs to be cooked for 2 hours at 180°C and it should be ready to serve at 18h00. Here’s what to do.

• Ensure the clock is set to the correct time of day, 13.00.

• Press buttons 2 and 6 until 02.00 is displayed.

• Press buttons 3 and 6 until 18.00 is displayed.

• Set the oven thermostat to 180°C and the multi function selector to the desired

mode.

Hint: It is not advisable to use the Autobake function for cooking periods that are less than 60 minutes.

Switching the oven off automatically

Suppose you have to go out and you will not be back in time to switch off a meal already cooking in the oven and requiring another 40 minutes before it is done. Proceed as follows:

• Press and hold button 2. The clock will display 00.00.

• Release the buttons and the clock will again display the time of day.

• The word AUTO and will light up in the display.

• After 40 minutes, the oven will switch off automatically and emit an electronic tone for about one minute (4 beeps every 3 seconds).

• To cancel the tone, press any of the buttons.

• The word AUTO will flash until button 4 is pressed and manual control is

restored.

• Return the multi function selector to OFF.

• The oven thermostat must be turned to the OFF position in an anticlockwise

direction.

Important

• If the Automatic start and or stop functions are not required, the clock must be set to manual mode. Unless this is done, the oven will not work. Press button 4

• Check that the Key lock is not activated. (See page 6)

321

+ 9 hidden pages