Dee Zee RAM-VB-112-SW1 User Manual
Item Number
RAM No-Drill TM Seat Bases
RAM-VB-112
Vehicle base for the
FORD EXPLORER (2002-NEWER)
FORD EXPLORER SPORT TRAC (2007)
MERCURY MOUNTAINEER (2002-NEWER)
SPECIFICATIONS
Placement
Passenger side on the floor, in front of seat
Drilling Required
No - uses existing seat bolts
Seat Configuration
Bucket
Construction/Finish
Steel/Black Powdercoat
Dimensions
A = 13", B = 3.63", C = 8.25", D = 17", Hole
Center = 11.25
Pole or Pedestal
Purchased Separately
Weight
9.1 lbs.
National Products, Inc.
RAM-VB-112-SW1
Features
Installs in minutes with no drilling required.
Misc.
The RAM-VB-112 will not fit in the Ford Explorer Sport 2-Door.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Item Number
RAM-VB-112
RAM No-Drill TM Seat Bases
National Products, Inc.
Vehicle base for the
FORD EXPLORER (2002-NEWER)
FORD EXPLORER SPORT TRAC (2007)
MERCURY MOUNTAINEER (2002-NEWER)
INSTALLATION INSTRUCTIONS
If installing this base with a RAM tele-pole™ assembly, attach the lower female pole prior to installing the No-Drill™
base.
1. Move the passenger seat to its rearmost position and remove the plastic trim, covering the seat frame leg closest to
the passenger side door. This piece may be replaced after installation or stored for later use.
2. Remove the front seat rail bolts using a 15MM socket wrench. Using an extension with the socket wrench is
recommended.
3. Without moving the seat, place the No-Drill™ base over the front seat bracket and inline with the exposed threaded
holes.
4. Re-install the seat bolts using the socket wrench with extension. Note that you may need to put some pressure on
the front of the seat cushion to assist in re-aligning the seat rail bolt holes. Start threading the bolts by hand if possible
to prevent any cross threading. Next, re-tighten the bolts.
Once installed, this base will lessen the amount of travel available to the passenger side seat.
National Products, Inc.
Phone: 206-763-8361
Fax: 206-763-9615
Address: 8410 Dallas Ave S
Seattle, WA 98108
Website: www.ram-mount.com
Email: staff@ram-mount.com
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
Loading...