DEAN Super Cascade Installation Manual

SUPER CASCADE

SERIOUS SPILLING OF HOT OIL ONTO FLOOR.

Open the fryer door. Check

prepared properly.

oil return line heater and solid

a few minutes to melt solid

Mix crumbs and oil by stirring

remaining crumbs. Push the red

oil back into the fryer vessel.

after all the oil has been pumped

FILTER OPERATIONS

FOR BEST RESULTS, ENSURE OIL IS APPROXIMATELY 3508F (1758C) BEFORE FILTERING.

FILTERING PROCEDURES

1. Turn fryer OFF. If fryer has an

shortening is used, turn the filter switch to the heater position for

shortening in the pump lines before filtering.

4. Pull the yellow oil return

handle out to open return line to the fryer. Turn filter switch “ON” to begin pumping clean oil back into the fryer. Allow the oil to flow for a few seconds to wash out sediment in the bottom of the cooking vessel.

that the filter is in the proper position under the fryer drain valve and is ready for operation. See flip-side of this card to ensure filter is

5. Use a brush to scrub around the

heating tubes to remove

drain valve handle in to close drain and fill fry vessel. The filter pump takes approximately 3 to 5 minutes to pump all the

3. Remove screen from fry vessel.

with a brush. Open the drain valve by pulling the red handle out. Then oil will drain from the fry vessel into the filter pan.

6. Allow the pump to run for 20 -

30 seconds after air bubbles appear in the fryer vessel before shutting off to clear shortening/oil from the return lines. Turn filter switch “OFF”

back into the fryer. Push the yellow oil return handle in.

WARNING!

ENSURE HOSES ARE CONNECTED PROPERLY AND DRAIN HANDLES ARE IN PROPER POSITIONS PRIOR TO OPERATING ANY SWITCHES OR VALVES. FAILURE TO DO THIS CAN RESULT IN SEVERE BURNS.

CAUTION

DO NOT DRAIN MORE THAN ONE FRYER AT A TIME INTO THE FILTER PAN TO AVOID

819-5664

7/98

SUPER CASCADE

Reinstall crumb catcher and

hold-down ring to prevent

paper. Latch hold-down ring

line to the fryer quick

pan cover and

crumb tray. Visually inspect

5. Lift out protection screen and

FILTER PREPARATION

1. Turn fryer “OFF”.

4. Remove filter

filter paper sheets. Scrape debris off top filter sheet. Remove hold-down ring. Discard top sheet if scuffed or darkened.

2. Disconnect oil return line

from fryer quick disconnect.

clean around the nipple in the pan bottom.

3. Pull filter unit from the fryer.

6. Reinsert the protection screen. Lay a new filter paper sheet on protection screen. Then lay the old bottom filter sheet on top of the new sheet.

7. Position the hold-down ring on top of the filter papers. Filter paper will be slightly larger than filter pan bottom. Ensure all paper edges are covered by

crumbs from escaping under

and filter papers securely against the filter pan bottom.

819-5664 7/98

8. Sprinkle 16oz of filter powder

onto filter paper in filter pan. Make sure top filter sheet is covered evenly.

filter pan cover. Slide the filter back into the fryer.

10. Reconnect filter oil return

disconnect. Close fryer door. The Super Cascade Filter is ready to operate. Turn filter power switch “ON” when ready to use.